Why is my pool pump tripping my breaker?
Why Is My Pool Pump Tripping The Breaker? If the windings inside the motor are shorting together due to heat or age, and your pump is drawing more current and heating up, you will likely notice it when you discover the pump has turned itself off.
How do I reset my Hayward EcoStar pump?
To manually clear, shut off the breaker supplying the EcoStar with power for at least 1 minute, then restore power.
Why does my Hayward pool pump keep shutting off?
Overheating. For safety reasons, many pool pumps are designed to shut off automatically if they begin to overheat. The mechanisms that perform this task are known as thermal overload switches. If your pump continues to shut off, it could mean that the thermal overload switches are going bad.
What does it mean when your GFCI won’t reset?
If the GFCI won’t reset, it could be because there is no power supply to the GFCI, or the GFCI may have gone bad. Note: If the GFCI trips every time you reset it, then there may be a dangerous current leak somewhere in the circuit. In that case, you may want to seek help from an electrician.
What to do if your Hayward pool pump goes bad?
Check timer clock or switch for burnt terminals or wires. Check capacitor for …capacitance or resistance with an Ohm meter. If breaker still trips, replace the breaker; they go bad eventually. If your Hayward pump runs for only 5 seconds and shuts off, check the incoming voltage.
Why are the Breakers on my Hayward pool tripping?
They are broken off of the flow switch. I did a little web research and found that the part is a HARWIL Q-12DS FLOW SWITCH. There is current running through it and if it is shorting then the GFCI is doing its job by tripping the breaker.
What kind of voltage does a Hayward pool pump take?
If your Hayward pump runs for only 5 seconds and shuts off, check the incoming voltage. Most inground Hayward pumps are shipped to accept 230V, and if you only give it 115V, it can’t get up to speed.
Why does the breaker trip when the pump is running?
If the breaker trips while the pump is running, the pump is likely drawing more amperage or voltage than the breaker rating. This could be caused by incorrect voltage or from clogged or restricted pipes, valves or impeller. It could also be just a bad breaker.