Why do you need ball joints and tie rod ends?
This kit from Whiteline includes extended ball joints and outer tie rod ends to move the pivot point of both suspension components to correct for the change in ride height. When a vehicle is lowered, the angle of the tie rods and lower control arm can add more body roll in addition to the undesirable bump-steer feedback in the steering wheel.
What do I replace my rubber ball joint or tie rod end dust with?
What do I replace my rubber Ball Joint or Tie Rod End dust boots with? – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
Do you replace tie rods on both sides?
Should tie rod ends be replaced on both sides at the same time? No, If a tie rod is in good shape, there is no need to replace it. Often, however, tie rods on both sides wear out at the same rate.
What do you need to remove lower ball joint?
Removing the front sway bar end links allows the control arms to move independently, which gave us the movement in the control arm we needed to remove the lower ball joint. The outer tie rod is connected to the spindle using a castle-type nut. A cotter pin holds the castle nut in place and must be removed before the 19 mm nut can be removed.
How do you replace an outer tie rod?
Move the pinch nut up to touch the outer tie rod end. This will mark the location of your outer tie rod end and you will know how far to thread on the replacement. Do not tighten the pinch nut. If you do, you will not be able to easily turn the outer tie rod end. Remove the cotter pin.
Do you separate ball joints and tie rod ends?
When working on suspensions, you are going to have to separate the ball joints and tie rod ends. Stacey shows you a few tricks on how to do this with out the need to invest in specialty tools. Loading…
How do you remove tie rod from steering knuckle?
Use it to pry the shaft out of the steering knuckle. Remove the outer tie rod end from the inner tie rod end. To do this, you will twist the outer tie rod end off of the spindle of the inner tie rod end. Turn it counterclockwise to loosen.
How do you remove a tie rod from a Dodge Journey?
The tie rod end adjusting lock nut or sleeve is loosened. Then, a tie end removal tool is used to separate the tie rod ball stud from the steering knuckle. The tie rod is then unthreaded from its connection to the inner tie rod end.