Where is the ABS valve located?
brake line
Valves. There is a valve in the brake line of each brake controlled by the ABS.
Where is the ABS unit on a Honda Accord?
The ABS control unit is up front under the dash on the passenger side. On the same year Honda Accord, the control module is located behind the rear seat on the passenger side. The Sumitomo ABS system in the 1992 Acura models is a four-wheel ABS system with wheel-speed sensors at each wheel.
When did Honda start using an ABS system?
In fact, one of Honda’s earliest ABS applications dates back to 1988 on the Acura Legend. The majority of new models are using Teves ABS systems. One of the systems used during the 1990’s was the Sumitomo ABS system, which was used on the 1992 Acura Integra, Legend and Vigor models, and Honda Accord.
What kind of ABS system does Acura have?
On the same year Honda Accord, the control module is located behind the rear seat on the passenger side. The Sumitomo ABS system in the 1992 Acura models is a four-wheel ABS system with wheel-speed sensors at each wheel. But it’s a three-channel system that controls both rear wheels as a pair.
What to use to relieve pressure on Honda ABS system?
Honda has a special T-handle wrench (07HAA-SG00100) that can be used for this purpose. To relieve pressure, turn the bleeder screw one complete turn (key off), then stop. Wait until the pressure is relieved, then close the screw.
The ABS control unit is up front under the dash on the passenger side. On the same year Honda Accord, the control module is located behind the rear seat on the passenger side. The Sumitomo ABS system in the 1992 Acura models is a four-wheel ABS system with wheel-speed sensors at each wheel.
In fact, one of Honda’s earliest ABS applications dates back to 1988 on the Acura Legend. The majority of new models are using Teves ABS systems. One of the systems used during the 1990’s was the Sumitomo ABS system, which was used on the 1992 Acura Integra, Legend and Vigor models, and Honda Accord.
On the same year Honda Accord, the control module is located behind the rear seat on the passenger side. The Sumitomo ABS system in the 1992 Acura models is a four-wheel ABS system with wheel-speed sensors at each wheel. But it’s a three-channel system that controls both rear wheels as a pair.
When do you replace an ABS control module?
Other vehicles may require the two components to be replaced as a unit. This is dependent on how well you can access it and how the new module is sold. Step 2: Move onto part 3 or part 4. Skip to part 4 if you only need to remove the module and not the solenoid block and motor.