When does the brake light come on the turn signal comes on?
when the brake is pushed in both the front and rear turn signal lights come on and stay solid even when the turn signal is on and they are on the passenger side only. Also when the turn signal is on for a right hand turn the brake light on the top of the cab blinks too.
When does pressing the brake pedal the passenger side turn?
If pushing on the brake will illuminate the signal lights then turning on the signal lights has got to illum. the brake lights NOW where this short is that’s what you or a repair shop will have to find! It is going to be at the rear light or wiring as the two circuits do not pass through a common switch or circuit. Not on this vehicle!!
Is there a problem with the brake light?
There is no problem with the driver side or left turn signal lights Since the STOCK tail light is red for brakes and amber for signal there are two seperate bulbs, not likely a bulb problem.The brake light circuit is shorted/bleeding into the signal light circuit! Is it wired for towing a trailer?
Why is the brake light amber and brake light red?
Since the STOCK tail light is red for brakes and amber for signal there are two seperate bulbs, not likely a bulb problem.The brake light circuit is shorted/bleeding into the signal light circuit! Is it wired for towing a trailer?
when the brake is pushed in both the front and rear turn signal lights come on and stay solid even when the turn signal is on and they are on the passenger side only. Also when the turn signal is on for a right hand turn the brake light on the top of the cab blinks too.
If pushing on the brake will illuminate the signal lights then turning on the signal lights has got to illum. the brake lights NOW where this short is that’s what you or a repair shop will have to find! It is going to be at the rear light or wiring as the two circuits do not pass through a common switch or circuit. Not on this vehicle!!
Why does my brake pedal light stop blinking?
When I turn on right side turn signal and press brake pedal, the indicator light stops blinking but exterior light still blinks. Could this be BCM problem? If so, could disconnecting battery reset it?
Why does my dash light come on when I step on the brake?
I suspect that you have a broken wire in the trunk that will cause this = bad ground. There is a connector in the rear wiring harness near the rear seat that gets corroded that will cause this too. Clean the connections there on both sides of the connector then put electrolitic grease in there to help prevent corrosion.
There is no problem with the driver side or left turn signal lights Since the STOCK tail light is red for brakes and amber for signal there are two seperate bulbs, not likely a bulb problem.The brake light circuit is shorted/bleeding into the signal light circuit! Is it wired for towing a trailer?
Why do my blinkers stop blinking when I apply the brake?
All of these problems mentioned can be the result of a bad ground. When you operate both blinkers and brake lights and the blinkers stop blinking, it’s because the circuit is not good enough to operate both lights. Bad ground. Same with headlights and blinkers. Probably the same with fog lights.
Since the STOCK tail light is red for brakes and amber for signal there are two seperate bulbs, not likely a bulb problem.The brake light circuit is shorted/bleeding into the signal light circuit! Is it wired for towing a trailer?