Is there a company that rebuilds Weber carbs?
Weber Carb Rebuilding Services We offer Rebuilding and Re-Jetting services for the Weber 32/36 DGV / DGEV / DFEV series, 38 DGES, 40, 42, 45, 48 and 50mm DCOE Sidedraft carbs, 44 and 48 IDF Carbs, 48 IDA and 40 and 46 IDA-3C Carbs. Re-Shafting Services are available for the IDA 3C Models and will be quoted before starting work.
Where can I get a Weber intake manifold?
SUNBEAM ALPINE WEBER DCOE INTAKE MANIFOLD. INSTALLATION KIT WITH TWIN WEBER 32/36 DGEV (ELECTRIC CHOKE) CARBS ON MERCEDES BENZ WITH 35/40 ZENITH CARBS. THESE INSTALLATION KITS ARE IMPORTED FROM GERMANY AND COME AS IN THE PHOTO.
Can a Weber be fitted to a Mercedes Benz?
INSTALLATION KIT FOR FITTING TWIN WEBER 32/36 DGEV (ELECTRIC CHOKE) CARBS ON MERCEDES BENZ WITH 35/40 ZENITH CARBS. THESE INSTALLATION KITS ARE IMPORTED FROM GERMANY AND COME AS IN THE PHOTO. THERE ARE NO INSTRUCTIONS BUT CUSTOMERS HAVE TOLD US THAT THEY ARE NOT HARD TO FIGURE OUT AND THERE CAR RUNS BETTER THAN EVER AFTER INSTALLING NEW WEBERS.
What kind of rebuilding services do I need for a Weber?
We offer Rebuilding and Re-Jetting services for the Weber 32/36 DGV / DGEV / DFEV series, 38 DGES , 40, 42, 45, 48 and 50mm DCOE Sidedraft carbs, 44 and 48 IDF Carbs, 48 IDA and 40 and 46 IDA-3C Carbs. Re-Shafting Services are available for the IDA 3C Models and will be quoted before starting work.
What kind of jet screen does Weber EFI use?
A closer look shows our Weber EFI on the right uses real Weber jet cover screens and the same type of fuel lines, carburetor screws, and brass top plugs as the Weber carburetors at the left.
Where can I get a Weber carb adapter?
Adapter kit, linkage. Retains stock air filter. Some installation modifications may be neccessary INSTALLATION KIT FOR FITTING TWIN WEBER 32/36 DGEV (ELECTRIC CHOKE) CARBS ON MERCEDES BENZ WITH 35/40 ZENITH CARBS. THESE INSTALLATION KITS ARE IMPORTED FROM GERMANY AND COME AS IN THE PHOTO.
Are there any issues with a Weber carburetor?
One issue with Weber conversions is vacuum advance signal. If your distributor took vacuum from the manifold, you should do the same with the new manifold. You may have to modify it, or use a port intended for a less important function such as pollution control (pollution control mods should be done only for off-road vehicles).
How is fuel drawn into a Weber DCOE carburetor?
In addition to a simple tube with a fuel nozzle design, Weber shaped the tube so that it was narrowest where the fuel was drawn into the air stream by using the Venturi principal. This promoted fuel draw and fuel distribution. Video 1.