Why is my Xfinity box light blinking?
What is this? The blinking white light on your Xfinity Cable Box is a way for it to indicate its current status visually. Here, it means that it is unable to connect to the network. It could be happening due to a signal disruption caused by an issue with the router or the wiring connected to it.
How do I force restart my Comcast cable box?
Press and hold the Power button located on the front of the TV Box for 10 seconds. The TV Box should automatically restart.
What does it mean when your cable box is blinking blue?
Weak Signal Strength Is the blue light sometimes flash intermittently while watching a program or using the Xfinity box? Simply push the power button on the cable box and wait for the light to turn red. Wait about 30 seconds and then push the power button again to restart the cable box and resume programming.
How do I get Comcast to send a refresh signal?
Performing a System Refresh on X1
- Press the A button on your remote control, or visit the Help section in Settings.
- Highlight the System Refresh tile, and press OK.
- Please remember that performing a System Refresh will interrupt all X1 TVs and recordings in your home for up to 10 minutes.
What does blue blinking light mean on modem?
Troubleshooting tip: If the light blinks blue for more than 5 minutes, check to make sure the green DSL cord is firmly plugged in to both the modem and the wall jack. If it blinks blue again for more than 5 minutes, service is not connected to that jack.
Why does my Xfinity box blink at 3 am?
If you’re an Xfinity X1 customer, your TV Boxes will automatically restart once per day to ensure that you have all of the latest software. This restart, also known as Daily Update Time, happens by default between 3:00 AM and 4:00 AM local time.
How do I turn off the blue light on my Comcast cable box?
Use the down arrow button to highlight Device Lights and press OK. Select Power Light Brightness and press OK. Use the left arrow or right arrow button to select the brightness level you want, then press OK. Press Exit to finish.