What to do if your Honda water pump is leaking?
Replace it with a shorter hose. If your suction hose is leaking, it can also prevent the pump from priming. Repair or replace the hose or the coupler, whichever is leaking. If the pump still won’t prime, check if the strainer head is clogged. If it is, simply clean it and try again.
What to do if your Honda strainer breaks?
To avoid this problem in the future, always use the appropriate Honda strainer with the pump suction hose, and avoid pumping water filled with abrasives. To fix the problem, carefully remove any debris while the engine is off, or take it to a certified repair location.
What causes water hammer on Honda water pump?
Make sure you always drain water from the pump housing after use. Water hammer can also be caused by shutting off the water flow too quickly with a very long discharge hose. If this is the case, either use a shorter discharge hose or shut off the water flow more gradually. Issue: Water is leaking between the engine and the pump case.
What should Hg be on Honda water pump?
Set the throttle to fast. If the pump is working properly, the gauge should read at least 20 inch Hg. If it’s lower, the internal components of the pump may be worn. If the engine is too slow, the engine could be the problem.
Do you wash your Honda Marine with fresh water?
Flushing with fresh water will prevent a buildup of deposits that can clog or corrode the water passages, sensors, and thermostat (s) in the cooling system. 2. Wash down the exterior with fresh water after each use. We suggest washing the exterior with Honda Marine Salt Terminator or a mild biodegradable detergent.
What’s the best way to clean a Honda outboard?
We suggest washing the exterior with Honda Marine Salt Terminator or a mild biodegradable detergent. Do not spray water into the air intake. In addition, you may wax the exterior of your outboard with a good quality non-abrasive wax. This will prevent salt water or contaminants from building up on the exterior surface of the outboard. 3.
How often should a Honda marine water pump be serviced?
7. Apply Honda Marine Waterproof Grease monthly to the lubrication points as shown in the owner’s manual under Servicing Your Outboard Motor. Fully greased components help to prevent salt water intrusion and subsequent corrosion. 8. Have the thermostat (s) and water pump serviced annually or every 200 hours of use.
Can a Honda marine engine be used in salt water?
Your Honda Marine engine is designed and manufactured to precise specifications to ensure years of trouble-free operation. Operating and storing of your engine in salt water or polluted water may have adverse effects on your outboard. The good news is most salt/polluted water problems can be avoided by following a few simple steps.