Do you need to add oil to Sanden compressor?
1. New Sanden compressors are shipped with all the oil required for a normal OEM system for which they were intended. In most cases no additional oil should be added. For R-134a A/C systems the original Sanden PAG oil shipped in the new Sanden compressor is the best lubricant for compressor durability. 2.
Can a receiver dryer be drained of oil?
Typically you’ll want to change the receiver dryer along with the compressor. The dryer cannot be drained of oil, so you have to make an assumption that 2 ounces are held in side the dryer.
How long does it take to drain a Sanden gas compressor?
Drain for about 3 minutes while turning the front shaft nut one half turn every minute. Also slightly tilt the compressor back and forth a few times to help the oil reach the oil drain hole. 2.
What kind of oil does Sanden sd7h15 piston compressor use?
All Sanden R-134a SD7H15 piston compressor models use the Sanden SP-15 PAG oil for service. SD5H models are shipped with the SP-20 PAG but can be serviced with the SP-15 PAG. Chrysler TR Scroll model compressors also use the SP-15 PAG oil for R-134a.
How to install an AC compressor by Sanden?
The following AC compressor install procedure by Sanden, covers the compressor oil and refrigerant specifications, and compressor replacement steps/tips. While installing an AC compressor, be sure to follow the precautions mentioned below for a safe installation.
How do you replace an air conditioner receiver drier?
Step 1: Measure the amount of oil in the receiver/drier. Measure the amount of oil in the old receiver/drier by pouring it into a graduated glass. If oil has leaked out of the system, use the manufacturer’s recommended amount to refill the receiver/drier. Step 2: Add oil to the receiver/drier.
All Sanden R-134a SD7H15 piston compressor models use the Sanden SP-15 PAG oil for service. SD5H models are shipped with the SP-20 PAG but can be serviced with the SP-15 PAG. Chrysler TR Scroll model compressors also use the SP-15 PAG oil for R-134a.
How do you remove a clutch armature on a Sanden compressor?
1. Removal of Armature Fixing Nut (Figure 1.) Insert three prongs of armature securing tool into the three holes on the armature. Then, serving the tool by hand remove the armature fixing nut with a 14mm socket. 2. Removal of Clutch Armature Assembly (Figure 2.)