How do I connect a nano station?
Make sure the Nanostation 2 (Nano for short) is connected to your computer’s network card with network cables, via the power injector (supplied with 12V either from the included wall-wart or another 12VDC source). There should then be at least one LED lit on the back of the Nanostation.
How does NanoStation M5 work?
We install a wireless device (either a Ubiquiti Nanostation M5 or Ubiquiti Nanostation Loco M5 depending on location) on the outside of your premises which then points to our network of repeater stations. This then passes the signal back to our core router, which then passes it to the internet.
How do I connect a wireless access point?
In this article
- Introduction.
- 1Connect the Ethernet port of your cable modem or router to your wireless access point’s Internet (or WAN) port using an Ethernet network cable.
- 2Connect your wireless access point to your computer using an Ethernet network cable.
- 3Turn on your DSL or cable modem and wait about two minutes.
What is a nano station M5?
The Ubiquiti NanoStation M5 (NSM5) is a high performance, low cost and extremely versatile Point-to-Point wireless bridge. The NSM5 comes with a redesigned, sleek and elegant form-factor, along with integrated Ubiquiti airMax (MIMO TDMA Protocol) technology. Ubiquiti NanoStation M5 Key Features: Great Performance.
How big is the nsm2 / M3 / M5 series?
NanoStationM2/M3/M365/M5 Dimensions 294 x 30 x 80 mm (11.57 x 1.18 x 3.15″) Weight NSM2/NSM5 0.4 kg (14.11 oz) NSM3/NSM365 0.5 kg (17.64 oz) Gain
How big is a nanostationlocom2 / locom5 / M9?
NanoStationlocoM2/M5/M9 Dimensions locoM9 164 x 72 x 199 mm (6.46 x 2.83 x 7.83″) locoM2/locoM5 163 x 31 x 80 mm (6.42 x 1.22 x 3.15″) Weight locoM9 0.9 kg (31.75 oz)
How big is a nanostationm2 / M365 / M5?
NanoStationM2/M3/M365/M5 Dimensions 294 x 30 x 80 mm (11.57 x 1.18 x 3.15″) Weight NSM2/NSM5 0.4 kg (14.11 oz) NSM3/NSM365 0.5 kg (17.64 oz) Gain
How is The Nanostation 2 connected to the computer?
Make sure the Nanostation 2 (Nano for short) is connected to your computer’s network card with network cables, via the power injector (supplied with 12V either from the included wall-wart or another 12VDC source). There should then be at least one LED lit on the back of the Nanostation.