Where is the DLC connector on a GM ABS?
Locate the DLC connector found under the dashboard and just above the pedals. Plug the computerized scan tool into it and power on the scan tool. Navigate to the “ABS” menu on the computerized scan tool by pushing the down arrow button. Select “Clear all codes.” Power off the computerized scan tool and disconnect it from the DLC connector.
Where are the ABS relays located on a car?
Locations may vary from vehicle to vehicle, but they are usually located fairly close to your battery or main fuse panel. If you are not sure where yours is located, consult your owner’s manual. Open the relay panel and examine the diagram printed on the inside of the cover. This diagram will show you the exact location of your ABS relay.
Where do I plug my ALDL cable into my car?
Ideally it takes just a few steps: plug the ALDL cable connector into your OBD port under the dash and into your PC ( see the instructions here ). Fire up your laptop and start whatever data collection or tuning program software you use, and turn the car key forward to start the data stream flowing.
What are East Penn booster cable and clamps?
PAGES 2 THRU 10 Booster Cables and Clamps East Penn booster cable sets are equipped with heavy-duty color-coded clamps. These clamps provide easy attachment on hard to reach side, top post, and remote battery access terminals. Colorful packaging assures high store display visibility along with convenient reusable storage.
Where can I get ABS fittings for free?
ABS Fittings – Fittings – The Home Depot Get free shipping on qualified ABS Fittings or Buy Online Pick Up in Store today in the Plumbing Department. #1 Home Improvement Retailer Store Finder Truck & Tool Rental
Where is the ABS code on a Honda?
To access the codes if the ABS warning lamp is on, find the ABS service check connector under the passenger side of the instrument panel. It has a two-wire connector on the end. Connect a jumper wire between the two terminals (key off).
When does the ABS unit detect an open circuit?
The operation time of any ABS solenoid valve exceeds a preset value and the ABS control unit detects an open circuit in one of the ABS solenoid circuits. When the output signals from the ABS control unit are not transmitted to the ABS solenoid valves.
What do you plug into the OBD port?
Plug a module into the OBD port, and you’re effectively patching into the vehicle’s engine control module, or ECM, which is the vehicle’s computer brain. The OBD port is a specialized connector with many individual pins and wires connected to that ECM.