What should I do after a timing belt change?
They have to recheck the work. Sounds like they botched the job and the cam timing is off, or possibly even worse.
What happens to Honda Accord after timing belt change?
ALSO your honda 4cyliner in the Accord has a BALANCE SHAFT belt as well. This is also a very precise allignment procedure while doing the T-belt service. This will make your cars engine vibrate in an unusual manner after a T-belt job.
When did I change the timing belt on my Mitsubishi Endeavor?
This video was made to show to the viewer how I changed the Timing Belt on a Mitsubishi Endeavor 2004 with a 6G75 engine (V6 3.8L ci 3797cc MFI GAS SOHC). 2003–Present? Mitsubishi Pajero (aka Montero / Shogun) All new replacement spare parts used were all cheap good quality aftermarket parts!!!
Can a timing belt change cause exhaust valves to burn?
That is absolutely ludicrous and even if the intake valves are not bent due to a mistake it’s also possible that the exhaust valves could burn depending on the cam timing situation. You cannot continue to drive the car like this; period. I would approach them one time about making this right.
How do you install a new timing belt?
Install the new timing belt over the timing belt pulleys. Do not pry or use force, loosen the motor mount and/or mounting brackets to loosely install the timing belt. NEVER PRY ON A TIMING BELT, PRYING THE TIMING BELT WILL DAMAGE THE TIMING BELT PULLEYS TEETH AND/OR FLANGE THAT YOU ARE LEVERAGING AGAINST.
How to remove timing belt and timing balancer?
Timing tensioner. Before moving on to the next step, it’s wise to drain the coolant. Place a pan under the car, and turn the petcock on the bottom of the radiator to release. Now that the coolant has been drained and the timing belt as well as the balancer have been removed, the water pump can come out. Remove the bolts in red (Figure 12).
How do you replace the timing belt on a Honda Accord?
Install the timing belt drive pulley. Install the tensioner. Install the water pump pulley. Install the camshaft pulley. Loosen and tighten the adjusting nut to tighten the tensioner belt. Install the timing balancer belt pulley and lower cover. Then, tighten the bolts. Install the crank pulley and bolt.
Why is the timing belt on my car not working?
If your car ran fine and then the motor stopped suddenly with a clunk and won’t restart, it is likely your timing belt. The timing on the engine must be set exactly, or the valves and the pistons may collide, resulting in very expensive engine repairs.