What kind of oil does a 1998 Honda take?
Engine Oil
| Viscosity: | 10W-30 (Above -7) 5W-30 (All TEMPS) SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 3.2 quarts. w/ofAfter refill check oil level. 3.5 quarts (with filter)After refill check oil level. |
| Torque: | 33 ft/lbs (Oil Drain Plug) |
How to get an oil change on a 1998 Honda Accord?
Push down firmly on the hood to secure it in place. Allow 12-24 hours for all of the oil to drain out of the old oil filter. Take your old oil and filter to a recycling facility. Most auto parts stores and repair shops accept these at no charge to you.
Why is the solenoid on my Honda Accord leaking oil?
On many Honda vehicles, the VTEC solenoid has been found to be the culprit. More commonly, the gasket could be faulty and all that needs replacing. When this solenoid is bad, the motor’s VTEC will not “activate.”. It is largely dependent on the engine’s oil pressure and engine temperature.
Where to put the Jack on a 1998 Honda Accord?
This procedure is correct for all 1998-2002 Accord models equipped with the 2.3L inline 4-cylinder engine. Since the jacking location on the Accord isn’t large enough to fit both a jack and a jack stand, you must raise the car by placing the jack on the front subframe.
Where is the oil filter on a Honda Accord?
The engine oil filter is located on the back of the engine, almost directly above the drain plug. Move the oil drain pan so that it is underneath the oil filter. Unscrew the oil filter by turning it counterclockwise until it comes free of the threads on the engine.
Push down firmly on the hood to secure it in place. Allow 12-24 hours for all of the oil to drain out of the old oil filter. Take your old oil and filter to a recycling facility. Most auto parts stores and repair shops accept these at no charge to you.
Why does my Honda Accord have an oil leak?
Oil leaks are often hard to pinpoint because the causes are varied. On many Honda vehicles, the VTEC solenoid has been found to be the culprit. More commonly, the gasket could be faulty and all that needs replacing. When this solenoid is bad, the motor’s VTEC will not “activate.”
This procedure is correct for all 1998-2002 Accord models equipped with the 2.3L inline 4-cylinder engine. Since the jacking location on the Accord isn’t large enough to fit both a jack and a jack stand, you must raise the car by placing the jack on the front subframe.
The engine oil filter is located on the back of the engine, almost directly above the drain plug. Move the oil drain pan so that it is underneath the oil filter. Unscrew the oil filter by turning it counterclockwise until it comes free of the threads on the engine.