Can a crank sensor be replaced on a 2000 intrigue?
Replacing the crankshaft position sensor or crank sensor on the 2000 Intrigue requires removal and installation of other engine and body parts on the vehicle. Open the hood on the Intrigue. Disconnect the negative battery cable from the battery using an open-end wrench.
What kind of engine does an Oldsmobile Intrigue have?
The 2000 Oldsmobile Intrigue was a four-door sedan offered in a GL and a GLS trim level. The 2000 Intrigue was equipped with a 3.5-liter V-6 engine that produced 215-horsepower and 230 foot-pounds of torque.
What kind of engine does a 2000 intrigue have?
The 2000 Intrigue was equipped with a 3.5-liter V-6 engine that produced 215-horsepower and 230 foot-pounds of torque. Replacing the crankshaft position sensor or crank sensor on the 2000 Intrigue requires removal and installation of other engine and body parts on the vehicle. Open the hood on the Intrigue.
What kind of crank sensor does GM 3.1L use?
Some late model 3.1L and all 3.4L GM V6 engines use two crankshaft position sensors. One crank sensor is called the 3X (or 7X) crank sensor and this bad boy is:
How to install a new crankshaft position sensor?
Lubricate the O-ring on the new crankshaft position sensor with a light coating of fresh engine oil. Insert the new sensor into the engine, with the outer angled section of the sensor facing upward. Do not twist the new sensor during installation or push on the mounting bracket.
Replacing the crankshaft position sensor or crank sensor on the 2000 Intrigue requires removal and installation of other engine and body parts on the vehicle. Open the hood on the Intrigue. Disconnect the negative battery cable from the battery using an open-end wrench.
The 2000 Intrigue was equipped with a 3.5-liter V-6 engine that produced 215-horsepower and 230 foot-pounds of torque. Replacing the crankshaft position sensor or crank sensor on the 2000 Intrigue requires removal and installation of other engine and body parts on the vehicle. Open the hood on the Intrigue.
The 2000 Oldsmobile Intrigue was a four-door sedan offered in a GL and a GLS trim level. The 2000 Intrigue was equipped with a 3.5-liter V-6 engine that produced 215-horsepower and 230 foot-pounds of torque.
How do you remove a crank sensor from an engine?
Remove the starter from the engine, exposing the crankshaft position sensor on the lower front of the engine block. Remove by hand the electrical connector from the crank sensor. Remove the single crank sensor mounting bolt using a ratchet and socket. Remove by hand the crank position sensor from the front of the engine.