Does Ryobi make a spindle sander?
RYOBI 80 Grit Spindle Sandpaper.
What is a spindle sander?
An oscillating spindle sander is a benchtop (or in some commercial models, floor-standing) woodworking tool designed to sand the edges of boards. The sander has a small tabletop and a sanding drum that protrudes up through the rear portion of the tabletop.
What do you use a oscillating spindle sander for?
What is a spindle sander used for? The Spindle sander has an oscillating sanding drum that moves up and down used for sanding curves of various sizes on the interior and exterior of your work piece as well as sanding detailed pieces and creating a smooth flat finish.
What is an oscillating spindle sander good for?
An oscillating spindle sander solves the problem by moving the sanding drum up and down, exposing more of the surface of the drum to the workpiece. The result is a smoother edge on your workpiece, free of burn marks. Oscillating spindle sanders have been in use in production shops for years.
What are oscillating spindle sanders used for?
The oscillating spindle sander, in addition to the steady rotation of the drum, moves the drum up and down during the rotations. This helps prevent static friction, which causes burns and band marks on the wood. It also increases the life of the sanding sleeve by spreading the wear across a wider surface area.
How do you sandpaper a tight corner?
Cut or fashion a 1/4-by-3/4-by-3-inch piece of wood into a long, sharp wedge. Fold the sandpaper over the sharp end and use it to sand inside tight corners. The wedge works similar to a surgical tool, allowing you to sand in short, focused strokes with some power behind them. Cut the wedge smaller if needed.
How do you strip wood spindles?
How to Refinish Wood Spindles
- Apply paint stripper to the spindle, either with an old paintbrush or by spraying it from an aerosol can.
- Let the stripper work for 10 to 20 minutes, and before it dries out, scrape it off with a wire brush.
- Apply a second coat of stripper to crevices and features that still appear dark.
What do you use to sand spindles?
Sanding intricately turned balusters or furniture legs is much easier with abrasive strips cut from a sanding belt. Slice or rip an appropriate-width strip from the belt, and wrap it around the turning. Then hold each end of the strip and pull it back and forth as if you’re shining a shoe.