What causes a misfire on a Honda Passport?
3.2L V6 Honda Passport: 1996, 1997, 1998, 1999. When an ignition coil fails, it’ll cause the engine to misfire. This misfire will cause the fuel injection computer to set a misfire code that’ll light up the check engine light (CEL) on your instrument cluster: P0300: Random Cylinder Misfire.
What should I do if my Honda check engine light is not working?
Check to see that all electronics in the vehicle are working properly (e.g. dash light, 12-volt power supply, interior lights). If everything is working properly, I would either test all the fuses (using a test light or a voltage meter is the fastest way to do that) or return the vehicle to the person who did the work. 5.
What does the code on the Check Engine light mean?
This onboard computer runs your car so that it has optimum fuel economy and low emissions. The PCM creates a code indicating what part or system is malfuntioning (electrical system, oxygen sensors, and so on). Your tech can get the code from the vehicle and look up its meaning.
Where is the oxygen sensor on a Honda Accord?
It’s just possible, though not common, that a technician wiping oil off the sensor damaged it somehow. On this 1991 Honda Accord, you can see how the oxygen sensor (little rat-tailed item) is located directly below the oil filter.
3.2L V6 Honda Passport: 1996, 1997, 1998, 1999. When an ignition coil fails, it’ll cause the engine to misfire. This misfire will cause the fuel injection computer to set a misfire code that’ll light up the check engine light (CEL) on your instrument cluster: P0300: Random Cylinder Misfire.
What makes the Honda check engine light work?
All Honda fuel caps have a ratcheting device built into the cap to achieve a good seal and keep you from over-tightening the cap. When tightening your fuel cap, be sure to turn it enough to hear at least three clicks; that ensures the proper torque was applied.
Can a check engine light be a problem?
If your car is running normally, and you have no problem driving it, the problem is not so severe that you need to panic. Of course you should not ignore the light; it is warning you of some problem with the emissions system.
How to test cylinder balance on a Isuzu Amigo?
You can perform the cylinder balance test yourself on your 3.2L V6 Isuzu Amigo, Rodeo, or Trooper (and 3.2L Honda Passport), TEST 1 will help you with this. You’ll need: An HEI spark tester. Battery jump start cables. A digital multimeter.
How can I tell if my RV water pump is grounded?
Use a volt meter to check to see if you have a full 12 volts at the pump, then double check that the pump is grounded. (It won’t work if it’s not grounded.) If you have checked all of these issues and you checked the areas mentioned in the first question, then you may need to fully replace the RV water pump.
Where do you check the ground on a Honda Accord?
If you don’t see ground, check for ground on the black wire at the transmission range selector with transmission in park or neutral and foot on the brake. If you don’t see ground, then check for a broken or open on the blue/black wire between the C101 junction connection and the ECM/PCM behind the engine near the firewall.
What to do if there is no water in your water pump?
If there is still no water, then it’s time to break down and actually examine the pump. It’s possible that something in the motor of the pump needs to be replaced or it’s time for a whole new unit. Here’s what to do. Grab a friend and ask them to turn the water pump off and on when you need it.