Can flywheel cause clutch?
In many cases, a faulty flywheel will cause the clutch friction disc to wear out early. If the flywheel is not spinning smoothly or is causing jerky gear changes, this can damage the clutch plate, leading eventually to a slipping clutch.
How to replace clutch and flywheel on Honda Civic?
Mate the transmission and engine block together and tighten the mounting bolts. Reconnect the shift linkage, starter, mounts, wire clips, axles, and balljoints. Be sure to torque the balljoints to 47 ft/lbs and axle nuts to 134 ft/lbs.
What happens when the clutch fails on a Honda Civic?
When the clutch fails, its not a matter of if it leaves you stranded; it’s when. A damaged clutch does not allow you to engage into gear and will have you calling roadside on a regular basis.
What’s the best way to remove a flywheel?
Remove the flywheel bolts. When removing the flywheel bolts, it is best to use an impact wrench as the flywheel itself will lean, making the removal more difficult than it needs to be. Grab the pilot bearing and use a hammer and socket to press it into the new flywheel.
Where are the transmission bolts on a Honda Civic?
Remove the transmission top mount’s 17mm bolts. Proceed to remove the front transmission mount (three 17mm bolts and two 14mm bolts). Remove the final 19mm mount bolt located behind the transmission. Once done, loosen all four bolts that connect the transmission housing to the engine.
How do you replace the flywheel on a Honda Civic?
Use the following steps to replace the flywheel and clutch on your Honda Civic. The quickest way to reach the clutch is from underneath the chassis. In order to do this, use a jack to raise the vehicle and a pair of jack stands to support the chassis in the air. Also use this as an opportunity to drain the transmission fluid. Figure 1.
What kind of clutch does a Honda Civic have?
This article breaks down a complicated process and takes you step-by-step in how to correctly replace the flywheel and clutch on your Honda Civic. This article applies to the Honda Civic (1992-2000). Your Honda Civic uses a hydraulic clutch system to engage the transmission into the gears.
Remove the flywheel bolts. When removing the flywheel bolts, it is best to use an impact wrench as the flywheel itself will lean, making the removal more difficult than it needs to be. Grab the pilot bearing and use a hammer and socket to press it into the new flywheel.
Remove the transmission top mount’s 17mm bolts. Proceed to remove the front transmission mount (three 17mm bolts and two 14mm bolts). Remove the final 19mm mount bolt located behind the transmission. Once done, loosen all four bolts that connect the transmission housing to the engine.