Can a riding mower drive belt be replaced at the same time?
Note: Because there is inter-play between the two drive belts in the variable-speed pulley system, it is a good practice to replace both riding lawn mower drive belts at the same time. Place the mower on a flat, level surface and set the parking brake to keep the mower from rolling while you’re working.
How much does it cost to replace a drive belt?
One of the symptoms of a loose drive belt is a loud squealing or screeching noise that lasts for a few seconds after the engine is started. Often, drive belts are replaced as a kit with the new tensioner and other hardware. Replacing the serpentine belt may cost from $75 to $250, depending on the car.
How often should you change your serpentine belt?
Serpentine belts can last for years and might only need to be changed once or twice over the life of the vehicle. The recommended industry standard is to inspect your belt at 60,000 miles for wear & tear and replace if necessary, and replace every 90,000 miles regardless of the appearance in order to reduce the chances of a breakdown.
What happens when you change your drive belt?
Also, if your car has hydraulic power steering, you will lose the steering assist, as the power steering pump will be disabled. In addition, the alternator will stop supplying electric power that is needed to recharge the car battery and run the vehicle electric systems. Old vs new drive belt. See larger photo.
When should a drive belt be replaced in your car?
A drive belt is made of long-lasting rubber-based material. In most cars, a drive belt is replaced between 40,000 and 70,000 miles, however, we have seen cases where the drive belt lasted over 100k miles. What makes the belt wear sooner? Water, road dirt, excessive heat and oil leaks can cause the belt to deteriorate prematurely.
How much does it cost to replace a serpentine belt?
For just the parts, most serpentine belts retail for $15 to $45, but if you needed to hire a mechanic to replace it, then the costs could increase to anywhere from the shop minimum, often around $75 to as much as $200 if the part is difficult to access and/or install for both the parts and the professional install.
When should you replace the serpentine belt?
Most serpentine belts need to be replaced every 40,000 to 70,000 miles. If there are signs of the belt rubbing on something, make sure to identify and repair whatever it was rubbing on to avoid damaging the new belt.
How do I replace the serpentine belt?
How to Change a Serpentine Belt Step 1 – Get Out Your Cars Diagram Step 2 – Turn Off Your Car and Keep It on Idle Step 3 – Pop the Hood Step 4 – Note How the Belt Functions Step 5 – Relieve the Tensioner Pressure Step 6 – Slide the Belt Off the Pulley Step 7 – Remove the Motor Mount Step 8 – Replace the Belt Step 9 – Clean Up