How are VSS pulses calculated on a speedometer?
Speedometer Scalars(We do not recommend that you manually adjust these values) VSS Pulses/Mile:This value is used to calculate the speed value for the engine routines and gauge cluster. It is the number of pulses received from the VSS sensor per mile traveled.
How is the Rev calculated on a speedometer?
If you know your gear, tire and location of your VSS sensor you can calculate this value manually. VSS Pulses/Rev:This is the number of pulses received from the VSS sensor per output shaft revolution (used to calculate trans output RPM). It is usually equal to the number of teeth on the VSS sensor (depending on the sensor location).
How does the speedometer work on a Honda Civic?
There are a few different key elements that go into how the speedometer in your Honda Civic works. Here’s a general idea of how it works. The vehicle speed sensor (VSS) gear is located on the transmission, and it sends an RPM signal to the engine control unit (ECU).
How do you change the speedometer on a new car?
To make changes enter in your new tire height (in inches) divided by your new gear ratio. When you have entered the correct values for your vehicle click the “Calculate for New Values” button. This will use the values you entered to determine the new VSS Pulses/Mile and Trans Revs/Mile found below.
How do you turn off the speedometer?
If your speedometer has rocker-type switches, de press the ap pro – pri ate end of the switch with a suit able tool (NOT a pen cil!) that is not likely t o break off in side the speed o meter. P ressing dow n at the top of the switch turns the switch ON, press ing in at the bot tom of the switch tu rns the switch OFF.
What kind of pulse generator do I need for speedometer?
SEN-4165 – 2,000-8,000 PPM Pulse (Using 1-4 Magnets) Magnetic Pick-up coil for transmissions without a speed cable or VSS output.
Where are the 10 DIP switches on the 900 SE Ries speedometer?
The 10 DIP switches on the back of AMETEK’s 900 Se ries speed om e ters must be set to the cor rect po si tions for the speed o meter to func tion prop erly. To de ter mine the cor rect po si tions and set the cali bra tion switches, per form the steps in Fig ure 1. Notes –This pro ce dure can be used as written for both Eng lish and met ric
How to set the cor rect Po Si tions on a speedometer?
To de ter mine the cor rect po si tions and set the cali bra tion switches, per form the steps in Fig ure 1. Notes –This pro ce dure can be used as written for both Eng lish and met ric speed om e ters. If your speedometer has rocker-type switches, de press the ap pro –