What is a Mercury Thunderbolt?
A year later, Mercury introduced the first in-line four- cylinder two-cycle outboard, the Mercury Thunderbolt, ushering in the modern era of outboards. To reduce emissions and make two-stroke outboards more efficient, Mercury was the first to introduce Direct Fuel Injection in 1996.
How do I cold start my Mercury outboard motor?
How to Cold Start a Mercury Outboard Motor
- Put the motor in neutral and fast-idle.
- Push in the key, turn to start, and hold it in until the outboard starts up.
- Release the key.
- If the motor begins to stumble at this point, bump the key again to engage the choke & primer.
- Repeat until the engine is running smoothly.
Is Mercury and Tohatsu the same?
Tohatsu is Japan’s oldest outboard manufacturer. Mercury Marine is a division of Brunswick Corporation and many of the smaller Mercury Outboards are just rebranded Tohatsu Engines. In addition, the entire line of Nissan outboards are rebranded Tohatsus.
What year model is my Mercury outboard motor?
Answer: Every Mercury outboard has a serial number label located on the transom bracket area of the engine. The latest serial number labels display a 2-digit number in a box at the lower right portion of the label. These digits coincide with the last two digits of the year in which the outboard was manufactured.
What does a mercury trigger do?
Mercury Outboard Triggers The inner ring of your flywheel has magnets which pass close to the triggers coils. Each time the magnet passes, the trigger sends a low voltage “signal” to the switchbox. Look-up the correct Trigger for your Mercury Outboard by using the PARTS CATALOG link below.
How do you start an outboard that has been sitting?
Get some water to the engine via a garden hose. Then put on some ear muffs and let the water run for a couple of seconds. Prime up the fuel, turn the key, and hopefully, start and run the engine! If you are going to let the engine sit and run for a while, (which is a pretty good idea to do).
How do you manually start an outboard motor?
Manually starting an electric-start outboard
- Remove the cowling.
- Tie a knot in the end of a 6 mm (1/4″) rope and wedge the knot into the notch on top of the flywheel.
- Wrap the rope around the flywheel in the correct direction (clockwise, for this 1994 Johnson J30).
- Set the choke and throttle.
- Pull really hard.
How fast can a 80 HP boat go?
Aluminum Outboard-Powered Boats When equipped with 250-hp or 300-hp outboards, these types of aluminum fishing boats can typically have a WOT of 55 mph to 60 mph, or a bit more with two people aboard. But you don’t have to put engines that large and expensive on a 16′ to 24′ aluminum fishing boat.