What does maint reqd mean on Honda CRV?
168 likes 290 answers. The maintenance light in Your Honda CR-V is an important signal that lets You know when Your vehicle is due for a service. This can be as simple as an oil change to one of the more intensive higher mileage services.
How do you clear the maintenance code on a Honda CRV?
This method should work on any Honda trim model that has a touch screen with a home screen.
- Press home.
- Select settings.
- Press vehicle settings.
- Scroll down to maintenance info and press it to select it.
- Press reset.
- A screen will pop up asking if you really want to reset it or cancel. press reset and that should do it.
Where is the reset button on a Honda CR-V?
Press the Select/Reset button located on either your steering wheel or as a knob on your dash. Depending on your model, either scroll through or press the knob repeatedly until “Engine Oil Life” or “Engine Oil Indicator %” is displayed.
When is the code detected on Honda CRV?
When is the code detected? The VTEC system activates the VTEC solenoid valve by command from the powertrain control module (PCM), and it charges/discharges the hydraulic circuit of the VTEC mechanism that is installed in the valve system to switch valve timing between Low and High.
Why does my Honda CRV have a p1259 code?
I’d been getting a P1259 for some time and ruled out the oil level. It just wouldn’t go away so I bit the bullet and rolled up my sleeves. I replaced the gasket and found the old one pretty full and clogged. It was a pain in the butt to get to, but I managed to do it. Was pretty happy until about a day after, the code resurfaced.
What to do if your Honda CRV has Gunk in it?
Also after changing the parts if gunk is found built up on parts, run a can of sea foam in the engine. 30 minutes at idle sitting still, once done immediately change oil and filter before driving.
How does the VTEC system work on a Honda CRV?
The VTEC system activates the VTEC solenoid valve by command from the powertrain control module (PCM), and it charges/discharges the hydraulic circuit of the VTEC mechanism that is installed in the valve system to switch valve timing between Low and High.
Where is the leak code on a Honda CRV?
Nytro97 is right usually the vent solenoid valve that rust out from the top where the 4 bolts sits & seals it. You can use soapy water to test it if it has a leak. But if you see rust , then just replace it. If you need a diagram I can give you a link on where to find it.
Where can I get 2003 Honda CRV parts?
RockAuto ships auto parts and body parts from over 300 manufacturers to customers’ doors worldwide, all at warehouse prices. Easy to use parts catalog. 2003 HONDA CR-V Parts | RockAuto
When do I get the Honda CRV owner’s manual?
Delivery time is approximately five weeks. To save paper and time, you can download the latest manuals now. Recommended Service for Your 2003 Honda CR-V Recommendations for regular servicing tasks for your vehicle can be found in Service & Maintenance .
What causes a Honda CRV canister to leak?
I had this on my 2002 CRV a few years back. It is probably the canister shut valve. My shut valve tested good electrically…my problem was corrosion of the metal that held it together. It was just leaking. It sits right next to the canister. I did it right in my garage, jacked up the left rear and set a jack stand for safety.