How do you remove plastic licence plate nuts?
Of course then I had to pop the tailgate panel open to remove the old nuts! So either way, you are probably going to have to pop open the bottom of the tailgate panel so you might as well do it now. Then you can get in there and grab the nylon nuts and get the screws out without wrecking anything.
Which is the best silicone license plate holder?
Aujen Silicone License Plate Frames, 2 Pack Car License Plate Cover, Universal US Car Black License Plate Bracket Holder. Rust-Proof, Rattle-Proof, Weather-Proof Car Accessories
What kind of license plate frame to buy?
Indeed BUY Newest 2 Pcs 4 Holes Stainless Steel Black License Plate Frame,Car Licenses Plate Covers Holders Frames for Plates with Screw Caps. Glass Diamond Car License Plate Frame – 2 Pack Handmade | Sparkly Bling Chrome Rhinestone Stainless Steel Metal Frames For Women & Men Cars Plates. AA SS16 Glitter Crystal (Glass Diamond Rhinestone)
What to do if your licence plate is spinning?
I bought a set of anchors and screws and some stainless steel washers at the car parts place (AutoZone or O’Reillys), opened the inside tailgate panel, removed the parts that were rattling, and securely installed the replacement anchors and the new screws. Thanks David for that input…
How do you remove a liftgate access panel?
Slide the trim tool between the metal hatch and the plastic and pull down. There are about 10-12 snap rivets holding the plastic on. Start closest to the seem for the lower part and upper part. I put painters tape around the edges to protect the paint and plastic.
Where is the override button on the liftgate?
It’s on the opposite side of the liftgate handle. Click to expand… If you are referring to the round access cover on the interior trim (for liftgate manual override), it just snaps in place. yep…get some of those plastic trim removal tools.
How to remove the liftgate on a 2014 Jeep?
If you are referring to the round access cover on the interior trim (for liftgate manual override), it just snaps in place. yep…get some of those plastic trim removal tools. I just did this Sat on my 14′ It was very easy and took less than 1 minute. Slide the trim tool between the metal hatch and the plastic and pull down.