Where is the distributor located on a 1989 Honda Accord?
Loosen two 12mm nuts that secure the distributor to the passenger side of the cylinder head. Rotate the distributor to set the timing to 18degrees +/- 2 BTDC (Before Top Dead Center) and retighten the distributor nuts. On the 1989 Honda Accord, 18 degrees is the middle mark (painted red) of the three marks on the crankshaft pulley.
Where is the timing connector on a 1989 Honda Accord?
The timing connector in the 1989 Honda Accord is located on the main wiring harness that runs along the driver side of the engine compartment and is identified as a two wire connector with a yellow cover over it. Start engine.
What are the parts of a Honda Accord?
Notes: Suspension Control Arm Kit — (SET OF 12) Front Control Arm Suspension Kit; Includes (2) Upper Control Arm and Ball Joint Assemblies, (2) Lower Control Arms, (2) Lower Ball Joints, (2) Inner Tie Rods, (2) Outer Tie Rods, and (2) Sway Bar End Links. Both Left and Right Sides 2.4L 2354CC 144Cu.
Where is the 18 degree mark on a Honda Accord?
On the 1989 Honda Accord, 18 degrees is the middle mark (painted red) of the three marks on the crankshaft pulley. The 18 degree mark should be centered in the timing pointer. Turn off engine and remove the paper clip from the timing connector and unclip the timing light from the battery and spark plug wire.
What happens if Honda Accord ignition lock cylinder is worn?
Ignition lock cylinder problems immobilize cars. A trip out should always result in a return home. But a worn Honda Accord ignition lock cylinder makes it very difficult, if not impossible to start the car. A missing set of keys has the same effect. Swap yours in less than an hour with basic tools from AutoZone’s Loan-a-Tool program.
What is the diysave10 code for Honda Accord?
Use Code: DIYSAVE10 Online Ship-to-Home Orders Only Your reliable Honda Accord takes you on your greatest road-trips, most memorable traffic jams and longest waits at the drive thru. Swap your Accord ignition lock with a part from AutoZone and turn that key with ease. Ignition lock cylinder problems immobilize cars.
Where is the ignition switch on a Honda Accord?
Begin on the left side and gently pull it off, so that all of the retaining clips are released. The ignition switch can now be unplugged for testing. The switch connects to the rear of the driver’s side fuse panel. Shine a flashlight and find the connector highlighted in red.
Why did my Honda Accord DX shut itself off?
A couple of years ago my 1998 Honda Accord Dx started shutting itself off at random times — on freeway onramps, while parked and idling, etc. — so I did some research and found that the electrical portion of the ignition switch had been recalled.