How do I reset my Atwood RV water heater?
How to Reset the Atwood Eco
- Turn off the power on the Atwood Eco water heater.
- Pull the junction box cover away from the water heater.
- Push the reset button in with your finger until it clicks into place.
- Place the junction box cover back onto the Atwood Eco and secure with the retaining nuts.
What is eco on Atwood water heater?
In regards to the Atwood RV Water Heater part # AT94022, the built-in emergency cut off (ECO) switch is a fail safe that will turn off the propane supply to the unit if the water gets too hot. …
What does the reset button do on a water heater?
Your water heater reset button is a safety device that shuts off power to your water heater when the water temperature inside it exceeds 180 degrees Fahrenheit. Side note: the reset button is also sometimes referred to as the ECO (emergency cut off) switch or “high limit safety thermostat switch”.
Why does my water not get hot in my camper?
Another easy troubleshooting step if there’s no hot water in your RV is to check your propane levels. If your propane tank is empty, or even if it’s very low, and you’re trying to heat your water using propane, you won’t get hot water.
Where is heater element of Atwood water heater?
The water heater element on your Atwood Gas and Electric RV Water Heater # AT94022 is located behind the gas line. Follow the two red wires (see attached photo) which are power wires connected to the back of the heating element to either unscrew or unbolt it.
How do you troubleshoot a gas hot water heater?
If troubleshooting a gas water heater, make sure that the gas is on, then relight the pilot flame with a BBQ lighter at the base of the water heater. If troubleshooting an electric heater, make sure the heater is receiving electricity, then reset the thermostat by pressing down the red reset button on top of the thermostat.
What is a power vent on a water heater?
“Power vent” is simply a term used to describe the way your water heater pushes out harmful combustion gases out your home. For some residences, depending on where your water heater is located, a power vent may be your only option.