Where is the OnStar module located in a 2005 Hummer H2?
The cellular modem connects the OnStar(R) system to the cellular carrier’s communication system by interacting with the national cellular infrastructure. The module sends and receives all cellular communications over the cellular antenna and cellular antenna coax. Ask Your Own GM Question
Is there a way to completely eliminate OnStar?
The only way to completely eliminate OnStar is to physically disconnect the module from your vehicle. Other than the OnStar system and its related services (Automatic Crash Response and Emergency Services), no other system in the vehicle should stop working when you disconnect the module.
Where are the connectors on my OnStar TV?
Locate the three cable connectors on the bottom of the silver box. To unplug a connector, grip its base with two fingers and press them inward, and then pull the plug straight out. Repeat until there are no cables connected to the silver box. These three cables provide power to the system and allow the system to communicate with OnStar.
Where does the OnStar signal go after muted?
After the audio system is muted, the OnStar(R) signals are transmitted to the audio system on the cellular telephone voice signal circuit, and returned to the module on the cellular telephone voice low reference circuit.
The cellular modem connects the OnStar(R) system to the cellular carrier’s communication system by interacting with the national cellular infrastructure. The module sends and receives all cellular communications over the cellular antenna and cellular antenna coax. Ask Your Own GM Question
The only way to completely eliminate OnStar is to physically disconnect the module from your vehicle. Other than the OnStar system and its related services (Automatic Crash Response and Emergency Services), no other system in the vehicle should stop working when you disconnect the module.
Locate the three cable connectors on the bottom of the silver box. To unplug a connector, grip its base with two fingers and press them inward, and then pull the plug straight out. Repeat until there are no cables connected to the silver box. These three cables provide power to the system and allow the system to communicate with OnStar.
After the audio system is muted, the OnStar(R) signals are transmitted to the audio system on the cellular telephone voice signal circuit, and returned to the module on the cellular telephone voice low reference circuit.