How do you turn off the airbag light on a 2012 Honda Civic?

How do you turn off the airbag light on a 2012 Honda Civic?

Place Your key into the ignition and turn it to the ON position. The SRS indicator will turn off after which You should quickly pull one side of the paperclip. The SRS light will turn on again. Reinsert the paperclip in no less than four seconds.

What does the SRS light on a Honda Civic mean?

The SRS light is there to tell you when something is wrong with your airbags, but sometimes it’ll stay on for no reason. Here’s how you reset it. This article applies to the Honda Civic (1992-2000).

How to reset Honda Civic airbag SRS light air bag?

Honda Airbag SRS Module Crash Reset After Accident. An error occurred while retrieving sharing information. Please try again later. AIRBAG LIGHT ON ?

Why does the airbag light stay on in a Honda Civic?

If all parts of this system are not working properly, it can cause the airbag light to come on. If you’ve been in an accident, the airbag light is going to stay on until the system has been restored. It will not work until repaired. Here are some common reasons that your Civic’s airbag light could come on. 1. Seat Belts

Why does the SRS light keep coming on?

For example, a long flash would indicate an error code of 10. Three short flashes would indicate an error code of 3. If there is an ongoing failure, the code will flash repeatedly. If the problem is intermittent, the code will flash once, and then the SRS light will just stay on.

The SRS light is there to tell you when something is wrong with your airbags, but sometimes it’ll stay on for no reason. Here’s how you reset it. This article applies to the Honda Civic (1992-2000).

For example, a long flash would indicate an error code of 10. Three short flashes would indicate an error code of 3. If there is an ongoing failure, the code will flash repeatedly. If the problem is intermittent, the code will flash once, and then the SRS light will just stay on.

Where is the SRS unit on a Honda Accord?

The SRS unit is mounted on the floorboard near the firewall, which is behind the stock radio. To access the unit, remove the center console and two side panels. There is one screw and one clip on the driver’s side. There are two clips on the passenger’s side.