What is standard center to center drawer pulls?
The Center-to-Center of any drawer pull is the distance between the center of one screw hole to the center of the other. Measuring the center-to-center of the drawer pull is key in determining what new hardware will fit and whether you’ll need to drill new mounting holes or fit into existing ones.
What is the standard size for drawer pulls?
For standard size cabinetry (dimensions of 12″ – 36″) the most common pull sizes are 3”, 4”, 96mm, and 128mm center to center (from one screw hole to another).
What does it mean to measure center to center?
It is the distance between the centre (the heart) of a column and the centre (the heart) of another column. By expressing a distance in c.t.c., one can measure distances between columns with different diameters without confusion.
Do drawer pulls go in the center?
As far as the height of your drawer hardware, the classic choice is to center them vertically. With multiple drawers stacked on top of each other, choosing this placement makes each knob a little lower and harder to reach.
How do you center drawer pulls?
Move the ruler across the drawer front diagonally in the other direction, from top right corner to bottom left corner. Trace the inner line of the ruler. Where the two lines intersect is the center point of the drawer, centered horizontally and vertically.
What size pulls for 36 drawer?
Cabinet doors 24-36 inches tall are best adorned with pulls 7-12 inches long, while cabinets taller than 36 inches such as pantries, built-in appliances and pullouts should be accompanied by pulls longer than 12 inches.
How do you measure center to center?
To find the center-to-center measurement, use a screwdriver to remove your current pulls, then take a ruler or measuring tape and measure from the center of one screw hole to the center of the other screw hole.
How do you install drawer pulls evenly?
Most drawer pulls are centered on the drawer fronts, but if the cabinet you’re working on has two or three drawers the same size and one larger one at the bottom, install the bottom knob (or pull) higher than the center of that drawer front. Install it so all the knobs on the cabinet are spaced evenly.
What does 3 in Center mean on drawer pulls?
Three inch hole center refers to the distants between the screw holes on the handle. If the door does not have existing handles or knobs you will have to drill the holes 3 inches from center to center and align you new handles to install.