How much is a diagnostic at GMC?
The average cost for a GMC Sierra 1500 general diagnosis is between $88 and $111. Labor costs are estimated between $88 and $111.
Do dealerships have better diagnostics?
The benefit of going to a dealership is that they are usually familiar with your type of vehicle and are aware of what the common problems are. They also generally have the most sophisticated diagnostic equipment. Most dealerships offer a flat rate charge (maybe $100) to diagnose any problem.
What is the GM service 4 wheel drive message?
GM has issued a service bulletin # 09-04-21-001 to address a Service 4 Wheel Drive Message condition on the vehicles listed below. In addition to the Service 4 Wheel Drive Message, you may also have a C0387 or a C0569 trouble code stored.
What happens when service 4 wheel drive trouble codes are stored?
When the trouble codes are stored and the Service 4 Wheel Drive Message is displayed, the transfer case is inoperative for the rest of that particular key cycle. It will test again and reset the message on the next key cycle if the problem hasn’t been fixed. The codes may be stored with or without you requesting a transfer case shift.
What causes a Duramax injection pump to fail?
As a result (allegedly), the lack of lubrication in the fuel can cause a premature failure of the injection pump, to a point where it won’t allow the LML Duramax to run. You can be driving down the road and everything seems normal, and when the pump fails, the truck just shuts off.
How long does it take for GM throttle body to relearn?
If you don’t do a relearn procedure, the PCM will “hunt” for a new baseline idle. It will eventually learn it on its own, but it may take over a week of driving, during which time you will experience high and low idle speeds and possibly rough idle. 1) Start the engine and let it idle in park for 3 minutes.
Where can I find help for my GMC?
Your GMC Owner Center Help & Support offers multiple topics of discussion to help you find the solution that you’re looking for. Help & Support | GMC Owner Center Your GMC Owner Center Help & Support offers multiple topics of discussion to help you find the solution that you’re looking for.
Why does my GM car say no start no crank?
How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.
What to do if your car ECM is not working?
The only way to be sure is to visit a mechanic with the proper computer. They can analyze your vehicle’s error codes, and let you know exactly what the problem is. If your ECM can’t make adjustments to your car’s timing or air to fuel ratio, the vehicle may not start at all.
What are the symptoms of a bad ECM computer?
There are a few things that can tip you off that there’s a problem. Here are the four most common symptoms of a bad ECM computer: There are many reasons your Check Engine light can turn on. These range from emissions problems to faulty O2 sensors to problems with the ECM.