Do you need a resistor box for high impedance injectors?
Peak and hold injectors only have a resistance of around 2-4 OHM. So with P&H injectors you need resistors or a resistor box to raise the resistance.
Can a Honda Accord have an ignition failure?
A very rare type of failure, but it does happen. If this is the condition that you’re experiencing, you will have to wait till your Honda does not start to test the ignition system. This is the only way to test for an intermittent problem.
How to test the ignition coil, ignition coil accord?
If you need the tutorial for the Honda ignition system with the ignition coil outside of the distributor, go here: How To Test The Honda Distributor Type Ignition System (Ignition Coil Outside Distributor 1992-2001 2.2L).
How can I find the correct resistance for my fuel injectors?
Tip: You can find the correct resistance for your injectors by searching online or in your vehicle’s repair guide. Step 1: Turn the car on. Turn the key to the second (ON) position for this test. You want battery power flowing, but don’t want the engine running. Step 2: Set up DVOM to measure DC voltage.
Can a fuel injector not receive the correct voltage?
It is possible for the injector to cause issues even if it is receiving the correct voltage. They can clog up, which will decrease the spray inside the cylinder. This, in turn, causes the fuel to not burn completely and will create a misfire.
A very rare type of failure, but it does happen. If this is the condition that you’re experiencing, you will have to wait till your Honda does not start to test the ignition system. This is the only way to test for an intermittent problem.
If you need the tutorial for the Honda ignition system with the ignition coil outside of the distributor, go here: How To Test The Honda Distributor Type Ignition System (Ignition Coil Outside Distributor 1992-2001 2.2L).
How much impedance does a solenoid injector have?
lbs/hour = cc per minute / 10.5 lbs per hour = HP / 2.04 cc per minute = lbs per hour x 10.5 HP = lbs per hour x 2.04 Injector impedance describes the electrical resistance of the solenoid windings. These are usually grouped in two categories: These type of injectors and drivers may also be called current sensing or current limiting.
How many amps does a saturated injector have?
Using Ohms’s Law we can calculate the current rating (12v/2 ohms = 6 amps). This is substantial current flow and a Saturated Injector cannot handle it. The drivers also come in two values; 4 amp peak/1 amp hold, and 2 amp peak/0.5 amp hold..