When to get the main relay checked out?
If the engine will not crank, then you will need to get the main relay checked out. If the main relay is not supplying the engine computer with the power it needs, then the engine will not be able to crank and run the right way. Failing to get the main relay replaced will usually lead to the car being unusable.
How to check the Honda main relay in your car?
Attach the battery positive terminal to the No. 4 terminal and the battery negative terminal to the No. 8 terminal of the main relay. Then check for continuity, using a circuit tester or multimeter, between the No. 5 terminal and No. 7 terminal of the main relay. If there is continuity, go on to Step 3.
How do you test for intermitted relay failure?
Step 1 – To test for intermitted relay failures which are common, remove the relay in question, take a small wire strand, about two inches long and insert it into the relay connector terminal 87 or 30. Step 2 – Next, reinstall the relay while keeping the wire strand inserted and clear of any other terminals or metal (ground).
How do you test a car relay with no power?
If there is no power, the electrical system must be tested starting with the fuse then the relay. If power is present use the test light connected to battery power to check the ground circuit. if these tests check out, the accessory is bad and needs to be replaced.
How can I tell if my main relay is bad?
If you can start your vehicle, you’ll notice a check engine light on the dashboard if you have a bad main relay. To verify that the engine light is for the main relay, you’ll need to connect an OBD II scan tool and read what the code is for, though.
When does a main relay need to be replaced?
If tapping the main relay does have the car startup, the main relay is going bad which needs to be repaired or replaced. Replacing the relay isn’t much difficult but repairing it will require electrical expertise. If you are unable to get your get running after checking all the basic things to check,…
Attach the battery positive terminal to the No. 4 terminal and the battery negative terminal to the No. 8 terminal of the main relay. Then check for continuity, using a circuit tester or multimeter, between the No. 5 terminal and No. 7 terminal of the main relay. If there is continuity, go on to Step 3.
Step 1 – To test for intermitted relay failures which are common, remove the relay in question, take a small wire strand, about two inches long and insert it into the relay connector terminal 87 or 30. Step 2 – Next, reinstall the relay while keeping the wire strand inserted and clear of any other terminals or metal (ground).