What happens to the EPs indicator on a Honda Civic?
If there is a failure in the system after the engine is started, the EPS indicator will stay on, and the power assist is turned off. When EPS indicator comes on, the control unit memorizes the DTC.
When does the EPs indicator go off on DTCs?
For except DTCs 22, 23, 64 or 66 the EPS indicator goes off automatically when the system returns to normal. For all other codes, the EPS indicator goes off when the system is OK after the ignition switch is turned from OFF to ON (II). Restriction on Power Assist Operation
What happens when power assist is turned off on Honda Civic?
If there is a failure in the system after the engine is started, the EPS indicator will stay on, and the power assist is turned off. When EPS indicator comes on, the control unit memorizes the DTC. In this case, the control unit will not activate the EPS system after the engine starts again, but it keeps the EPS indicator on.
Where is the HDS on a Honda Civic?
With the ignition switch OFF, connect the HDS (Honda diagnostic system) to the data link connector (DLC) (A) located under the dash on the driver’s side of the vehicle. 2. Turn the ignition switch ON (II). 3. Make sure the HDS communicates with the vehicle and the EPS control unit.
If there is a failure in the system after the engine is started, the EPS indicator will stay on, and the power assist is turned off. When EPS indicator comes on, the control unit memorizes the DTC.
Why is the DTC not memorized on Honda Civic?
This usually occurs when turning. If the car’s CPU can’t be activated when the EPS light comes on, the DTC is not memorized. If the code is not memorized, the EPS light stays on. Codes memorized cannot be erased by disconnecting the battery. Codes 22, 23, 64, and 66 will remain memorized after the ignition is turned off and the EPS turned off.
For except DTCs 22, 23, 64 or 66 the EPS indicator goes off automatically when the system returns to normal. For all other codes, the EPS indicator goes off when the system is OK after the ignition switch is turned from OFF to ON (II). Restriction on Power Assist Operation
If there is a failure in the system after the engine is started, the EPS indicator will stay on, and the power assist is turned off. When EPS indicator comes on, the control unit memorizes the DTC. In this case, the control unit will not activate the EPS system after the engine starts again, but it keeps the EPS indicator on.