How do you remove a pillar on a Honda Accord?
3. Pull back the top of the A-pillar trim (A) by hand to remove the upper clip (B) from the body (C). 4. Pull out the A-pillar trim (A) by hand to detach the clips. Pull up the trim from the dashboard (B), then remove the trim.
Where do you put the trim on a Honda Accord?
Place the trim over the A-pillar (C), and fit its upper clip (D), the lower clips, and the pin (E) into the holes (F) in the A-pillar, then lightly push the trim into place. NOTE: – Make sure the side curtain airbag is not tucked under the clips or the trim ribs.
Where are the SRS components located on a Honda Accord?
SRS components are located in this area. Review the SRS component locations, 2-door (see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repairs or service.
How do you replace a side curtain trim?
Pull out the A-pillar trim (A) by hand to detach the clips. Pull up the trim from the dashboard (B), then remove the trim. 5. If the side curtain airbag has been deployed, replace the A-pillar trim with a new one (see page 24-208). 6.
How to remove the trim from a Honda Accord?
2. Lower the coat hanger (A), then remove the screw. 3. Pull down the front edge of the C-pillar trim (A) from the B-pillar upper trim (B) by releasing the hooks (C), and pull down the roof area of the C-pillar trim by detaching the clips and releasing the projection (D). 4. Remove the B-pillar upper trim (A). -1.
3. Pull back the top of the A-pillar trim (A) by hand to remove the upper clip (B) from the body (C). 4. Pull out the A-pillar trim (A) by hand to detach the clips. Pull up the trim from the dashboard (B), then remove the trim.
Place the trim over the A-pillar (C), and fit its upper clip (D), the lower clips, and the pin (E) into the holes (F) in the A-pillar, then lightly push the trim into place. NOTE: – Make sure the side curtain airbag is not tucked under the clips or the trim ribs.
Pull out the A-pillar trim (A) by hand to detach the clips. Pull up the trim from the dashboard (B), then remove the trim. 5. If the side curtain airbag has been deployed, replace the A-pillar trim with a new one (see page 24-208). 6.
SRS components are located in this area. Review the SRS component locations, 2-door (see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repairs or service.