How do you size a Speedi-sleeve?
To determine the appropriate sleeve size, it is first necessary to clean the shaft carefully. The diameter of an undamaged section of the seal counterface should then be measured on at least three different planes. The arithmetical mean of these measurements determines the size of SKF SPEEDI-SLEEVE.
How thick are speedi sleeves?
The Speedi-Sleeve is thin-walled, 0.011 in (0.28 mm), and made of high quality stainless steel. The contact surface is wear-resistant and machined to minimize directionality (0° ±0.05) with a finish of Ra 10 to 20 µin (0.25 to 0.5 µm), depending on size.
How do you cut a Speedi-sleeve?
A SPEEDI-SLEEVE can be removed by applying heat to the sleeve with an electric heat blower, which will expand it enough to let it slide off the shaft without causing damage. by using a pair of wire cutters starting at or near the flange and applying a twisting motion.
What is a ready sleeve?
Redi-Sleeves are fast, inexpensive repair options for grooved or worn shafts. Redi-Sleeves are pressed onto a shaft where indications of seal wear, such as tracks or grooves, have developed. Using a Redi-Sleeve gives the shaft a smooth, ideal sealing surface.
What is a sleeve and seal?
A Sleeve N Seal is a thin-walled metal ring ~1″ deep with an accompanying tube of “seal”. It comes with some timing cover gasket sets. To install it, you heat the ring up in the oven on 500 degrees for 10 minutes.
What is a speedi seal?
SPEEDI-SLEEVE® THE SPEEDI-SLEEVE® CONCEPT. the quickest and sensible way. to repair worn shafts. To seal efficiently, radial shaft seals must run against a smooth round surface – the seal counterface.
What is a speedy sleeve?
What is a stack sleeve?
FUNCTION: Used as a watertight sleeve for piping which passes through concrete floors and walls. Sleeve has integral cast flashing flange for use in waterproof floors. After riser is passed through sleeve, a waterproof caulked joint is made at the top hub.