How do you change the suspension height on a Range Rover?
Press and hold to raise the rear suspension. Press and hold to lower the rear suspension. Simultaneously press and hold both buttons to set the rear suspension to the normal height setting.
How do you lock the air suspension on a Range Rover?
2016 Range Rover Make sure that the suspension height is set at the access height setting or the normal height setting. Make sure that the vehicle is travelling at a speed of less than 35 km/h (22 mph). Press the down button (2) for longer than 1 second, to lock the vehicle at access height.
What are the symptoms that indicate a problem with an automobiles height sensor?
What are some symptoms of a bad Ride Height Sensor? An uneven ride height at any one of the corners or the illumination of a warning light related to the air suspension system are the most common symptoms.
How do you turn on auto access height on a Range Rover?
To lower the vehicle to the full access height setting, press the down button (2). The full access height setting is 40 mm below the normal height setting. Auto access height can be activated until 90 seconds after the vehicle becomes stationary.
How do you reset the height on a Range Rover?
Selecting a new height using the raise/lower switch 1, or driving off will reset the system. If the vehicle is grounded and traction control is activated, Extended mode is activated automatically to raise the vehicle clear.
What is Range Rover access height?
The full access height setting is 2 in (50 mm) below the normal height setting. Auto access height can be activated until 90 seconds after the vehicle becomes stationary. Auto access height only operates once for each time the vehicle is stationary.
What does suspension ride height sensor do?
The Suspension Ride Height Sensor is an electronic device that measures the distance between the road and a particular point on the vehicle’s suspension, chassis or body. Based on the output of the sensor, the Engine Control Unit (ECU) makes the compressor determine whether to fill or release air from the air bags.
How do you put a Range Rover in jacking mode?
Turn half a turn counter-clockwise. Position the jack under the relevant jacking point (1) on the vehicle. Do not allow the jack to contact the sill at any other point, as damage may result. Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point.