How do you reset the maintenance light on a 2006 Honda Pilot?
Press the “SELECT/RESET” knob until the engine life indicator is displayed. Press the “SELECT/RESET” knob for more than 10 seconds, the indicator and the maintenance code(s) will blink. Press the “SELECT/ RESET” knob for 5 more seconds, the maintenance code(s) will disappear and oil life will be reset to 100.
What causes the p0159 OBD-II trouble code?
Code P0159 is a powertrain code that indicates a specific sensor in the exhaust system (bank 2 sensor 2) is not performing as it should. When an oxygen sensor modulates slowly, it is an indication it is bad. This sensor monitors the catalyst efficiency for emissions purposes. What causes the P0159 code?
What does a p0157 mean on a catalyst?
If you have a P0157, that doesn’t mean your catalyst is bad (in fact, it usually never does). This code basically means that the Bank 2, Sensor 2 (or second o2 sensor back on bank 2) signal voltage is below what is considered normal for that sensor.
What causes p0157 to set on rear O2 sensor?
If the PCM determines that the post-cat o2 sensor signal voltage is below a certain threshold for too long, P0157 will set. Usually rear o2 sensor problems won’t cause drivability issues since they are an input that measures catalyst efficiency (unlike front o2 sensors).
What does a code p0153 on an oxygen sensor mean?
A code P0153 may mean that one or more of the following has happened: The oxygen sensor is faulty The wiring to the sensor is broken / frayed There is an exhaust leak Things that may fix the problem include: Check and fix any exhaust leaks Check for wiring problems (shorted, frayed wires)
What’s the OBD code for a Honda Pilot?
“Please verify these Generic OBD II Code descriptions and testing procedures with an appropriate manual. We do frequently update this Generic Check Engine Light Codes list, but technology is constantly in motion.
What are the p1151 and P1152 codes?
The truck started generating p1151 & p1152 codes (engine lamp on) immediatly after I put a clutch in it. The engine lamp was off and every thing was fine before I put the clutch in. I checked the wires and pins in the connector going to…