What should I do if my crankshaft sensor has been replaced?
Original Fix: Crankshaft sensor has been replaced. Less than an hour later it would not start again. Waited two hours and would not restart. Tapped on starter and vehicle started right up with check engine light. Still showing original code saying to replace crankshaft sensor.
Why is my crank and cam sensor not working?
If it is giving a signal, then the cam and crank signals are way off and causing the wrong ignition timing. If you need to have a local expert come check this problem for you, a certified technician from YourMechanic can come to your car’s location to diagnose the hard starting issue and pinpoint the correct fix.
What does the code for crank sensor mean?
the code for crank sensor does not mean the sensor needs to be replaced. it means the ecm does not recognise the signal, the signal is not there or it is erratic. thats why you pay for a real diag instead of a free diag from a parts person who has never fixed a car. So this sounds similar to what we are experiencing with our 2003 HSF 2.4L…
Original Fix: Crankshaft sensor has been replaced. Less than an hour later it would not start again. Waited two hours and would not restart. Tapped on starter and vehicle started right up with check engine light. Still showing original code saying to replace crankshaft sensor.
How does the crankshaft position sensor work on a car?
Depending on the vehicle, the PCM uses this crankshaft position information to time the spark properly or on some systems it is only for misfire detection and does not control spark timing. The CKP sensor is stationary and works in harmony with a reluctor ring (or toothed ring) that is attached to the crankshaft.
Why is my p0335 crankshaft position sensor not working?
ALL CAM AND CRANK SENSORS HAVE BEEN REPLACED TWICE , CAR WIL ALLWAYS CRANK AND RUN FINE TIL YOU DRIVE ABOUT 20 MINS. THEN IT JERKS AND BUCKS VILOLENTLY THEN QUITS CODE PO335 KEEPS COMING BACK , PERFORMED WIGGLE TEST CHECKED ALL , CONNECTORS AND PIN , WIRING HARNESS ETC , ONLY THING NOT REPLACED IS
Why does my Santa Fe engine shut off while driving?
From what I’ve been researching the Santa Fe’s have a faulty “Crank-Shaft Sensor” in which it makes the SVU just shut off while driving. The manufacture knows of this problem but continues to ignore any and all permanent solutions. This problem isn’t the worst part though!
What are the codes for the crankshaft position sensor?
A diagnostic scan tool could show any of the following codes: 1 P0335 Crankshaft Position Sensor A Circuit Malfunction 2 P0336 Crankshaft Position Sensor A Circuit Range/Performance 3 P0337 Crankshaft Position Sensor A Circuit Low Input 4 P0338 Crankshaft Position Sensor A Circuit High Input 5 P0339 Crankshaft Position Sensor A Circuit Intermittent
What happens to the crank sensor on a GMC?
The crankshaft sensor on GMC vehicles is synced to the powertrain control module, or PCM. When the crank sensor is replaced, it must be resynced to the PCM. Without resyncing, the PCM cannot properly determine the position of the crankshaft.
What happens when crankshaft position sensor ( CKP ) fails?
If the sensor (CKP) has failed completely, then the computer won’t send any fuel to the injectors. Consequently, Leaving you unable to start the car. A Crankshaft Position Sensor (CKP) Failure may cause the check engine light on your dashboard to come on.