How do you reset the maintenance required light on a 1998 Honda CRV?
Turn off the engine. Press and hold the select/reset button(s) on the instrument panel, then turn the ignition switch ON (Position II). Hold the button(s) for at least 10 seconds, until the indicator resets.
When to reset the Check Engine light on Honda Civic?
Continue reading to learn how to reset this light and save yourself the dealership cost. This article applies to the Honda Civic (1992-2000), and Accord (1990-2002). The check engine light in your Honda offers important diagnostic information, which will alert you of a serious problem like a bad catalytic converter.
Is it possible to reset the Check Engine light?
Blue jumper plug with brown and black wires. While it is possible to reset the CEL light at this time, your best option is to decipher the trouble codes provided by the system. Doing so will help you to determine if further diagnostics are needed.
Where is the Check Engine light on a Honda?
Turn the key into the “off” position if either of these occurs. Figure 1. A steady check engine light. (Related Article: Warning Lights – Honda-Tech.com) In the passenger’s side foot well, remove the kick panel by the side door. This will allow you access to the Engine Control Unit (ECU) and jumper plug (service connector).
How do you reset the lights on a Honda?
Observe the instrument panel to make sure the warning light or lights have shut off. Press and hold the reset button, located under the odometer. Turn the ignition key to the “on” position while still depressing the reset button. Hold the button until the light turns off.
Where is the reset button on a Honda Accord?
Press and hold the reset button, located under the odometer. Turn the ignition key to the “on” position while still depressing the reset button. Hold the button until the light turns off.
How to reset the computer on a Honda CRV?
Without either cable anywhere near the terminals of the battery, touch them together. Hold for 10-20 seconds, then take them apart and then put them back on the battery one at a time, not letting anything touch again. Start the car and let it run until the radiator fan kicks on, prob after 10 min or so, and your done.
How to reset the ECU on a Honda CRV?
Or you can do the ECU reset from the manual…..Pull the back up fuse. Touching the battery cables together after disconecting them from the battery is not necessary. All you need to do is wait. Ten minutes ought to be more than enough and five should be sufficient.