What does ESP stand for in oil and gas?
The electrical submersible pump, typically called an ESP, is an efficient and reliable artificial-lift method for lifting moderate to high volumes of fluids from wellbores.
What is seal chamber?
The component located below the lowest pump section and directly above the motor, in a standard electrical submersible pump (ESP) configuration, is the seal-chamber section. The seal-chamber section is basically a set of protection chambers connected in series or, in some special cases, in parallel.
What is an ESP protector?
One of the main functions of an ESP Seal Chamber Section (also known as a “Protector”) is to provide a rotating mechanical seal to protect the motor oil from contamination. These seals are susceptible to damage due to a high concentration of fines in production fluids scoring the sealing surfaces.
What are ESPs used for?
An electrostatic precipitator (ESP) removes particles from a gas stream by using electrical energy to charge particles either positively or negatively.
What pumps are used in oil wells?
6 Types of Industrial Pumps Used in the Oil and Gas Industry
- Centrifugal pumps.
- Reciprocating plunger pumps.
- Progressive Cavity pumps.
- Gear Pumps.
- Diaphragm pumps.
- Metering pumps.
What is seal chamber in mechanical seal?
Component, either integral with or separate from the pump case (housing), which forms the region between the shaft and casing into which the mechanical seal is installed. Seal face. Side or end of a mating ring or seal ring which provides the sealing surface on the ring.
What is seal chamber pressure?
The seal chamber pressure is a function of wear ring clearance as well as size and location of the balance holes. Two Stage Horizontal Pumps. Impeller arrangement can have two. configurations: 1.)
Which of the following component prevent contamination of the ESP motor oil from well fluid?
Applications. Our modular protectors perform in almost any well type (vertical, horizontal, directional) as a vital part of the ESP system. They provide a seal to prevent contamination of the ESP motor oil and carry the thrust load of the pump.
What is a rod pump?
Rod pumps are the most common form of artificial lift for oil wells. Today, these systems are used to lift formation fluids from more than 600,000 wells. A rod pump system consists of a prime mover, a surface pump, a sucker rod string and a downhole pump (Figure 1).
Is ESP same as traction control?
ESP is designed to stop skids while you’re on the move, retaining control of the car if you corner too fast, or hit a patch of ice, for example. Traction control is specifically designed to maintain grip at the driven wheels, which will vary depending on whether your car is front-, rear- or all-wheel drive.