How to change the battery in a car?
Operate the window control switch once to the close position. 6. Repeat the door window motor initialization for each door window motor. Switch off ignition. 2 Disconnect battery for 30 seconds reconnect battery (not required if battery changed). 3 Start the engine.
Can a car pass a smog test after battery was changed?
I was told it could not pass a smog test until the computer was reset; at a cost of $135.00.This car has always past before. What difference would this make if they are sticking the tester in the exhaust pipe?
What to do when a new battery is installed?
Step 1 – After a new battery has been installed, the engine could idle low or stall out altogether. When this happens hold the accelerator pedal to help engine to continue to run.
Why does my Honda Civic won’t start?
2013 Honda Civic No Start, No Sound, No Crank when you turn the key in the ignition: If nothing happens when you turn the ignition key to the “Start” position, it means that the starter motor doesn’t turn over the engine. Most commonly this could be caused by a low/dead battery or there is no connection between the battery and starter.
Why does my Honda Civic not start after battery replacement?
There is a risk jump starting these cars if you don’t follow a specific procedure – the ground (-) lead to your car must be connected to the engine block and max booster voltage is 15 volts or else you may damage the electrics with stray currents. When did the flashing light start – just since the new battery or when you first had the issue?
What happens to the Immobilizer when the battery dies?
The immobi codes get out of sync when the battery dies (actually it happens right when you crank with a dead battery). There should be some sort of TSB on this… I believe there was a campaign to repair cars in the market. If you bought the car certified, they should have fixed this.
How to reset my Honda radio after putting in a new battery?
Step 1 Turn the ignition key to the “On” position, but don’t start the engine. Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display. Release the power button when the display lights up and the radio turns on.
What happens when you replace the battery in a car?
Replacing the battery on some vehicles may simply be plug-and-play — just remove the old one, put in the new one, and you’re on your way. But some cars can react differently when you disconnect and then reconnect the primary source of power.
Operate the window control switch once to the close position. 6. Repeat the door window motor initialization for each door window motor. Switch off ignition. 2 Disconnect battery for 30 seconds reconnect battery (not required if battery changed). 3 Start the engine.
How do you remove a car battery cover?
Disengage the battery trim cover by twisting the clips 90° counter-clockwise. Remove the battery cover from the vehicle. Remove the battery fasteners (green arrows) and remove the bracket. Using a ratchet and a 10mm socket, disconnect the negative (-) battery cable (green arrow), then disconnect the positive (+) battery cable (red arrow).
Do you need a different battery for a convertible E46?
If you own a convertible E46, you require a different battery than standard models. Convertible model batteries are designed to tolerate the vibrations and movement due to convertible chassis design. Before disconnecting your battery, remove the key from the vehicle and store in a safe place and note any radio presets.
How to reset the battery after a flat battery?
5 Lightly press the foot brake. 6 Apply the parking brake by using the EPB switch. 7 Release the parking brake. 8 Release the foot brake. 9 Confirm that the brake warning lamp is no longer illuminated on the instrument pack and that “NOT CALIBRATED” message is no longer displayed in the message centre.