How do you fold a Stow and go seat?
Pull the release strap that comes out of the back and pull it clear of the mechanism and straighten it out. slip the lever back on and the seat should fold. Fold it up all the way to make it easier to reassemble. Pull the lever back off and slip the release strap back into the slot and make sure it is not twisted or kinked.
Where are the Stow and Go seats in a Dodge?
Step 1: Move the front seats all the way forward. Then locate two panels made of carpet on the floor in front of the middle seats. Store these panels off to the side for the moment; the spaces that hold the seats needs to be clear for the next steps. Step 2: Locate the lever on the side of the seat.
Where is the Stow and go seat cord?
The cord will be off to the side behind the rear seats. Pulling on this will fold the headrests down and will fold the backrest half of the seat down flat onto the other half. Note: On some models, the rear portion of the seat does not lay totally flat until Step 3. Step 3: Find the cord marked with a “2”’ and pull on it.
How do you Stow the rear seats in a car?
Step 1: Open the rear hatch and empty the trunk. The trunk has to be totally clear in order for the rear seats to be stowed – they will eventually be tucked away underneath the floor of the trunk. If there is a mat or cargo net on the floor, remove it before continuing. Step 2: Locate the inch-wide nylon cord labeled with a number “1”.
Where are the Stow and Go seats on a Dodge Caravan?
In the eleventh edition of the “Brandl Media Minute,” LT the Media Manager gives you the rundown on how to how lo operate the Stow and Go Seats on equipped Dodge Grand Caravans and Chrysler Town and Country’s. He goes through the steps it takes to stow seats both in the second and third rows.
Why are the seats stuck in the folded stow position?
They are stuck in the folded stow position. I had a similar situation. The problem was that when folded, the seats rubbed tightly against each other. I had to reach down between the seats, grab one, and really yank at it to get it to come up.
What’s the best way to move a car seat?
Loosen the bolts for one of the seats and use a lever (I used a large screwdriver) to reposition/rotate the seat slightly. Tighten the bolts and try moving the seats. The idea is to reposition the seat so that it does not rub (as much) against the other seat or the side of the seat well.
What should I do if my car seat is rubbing against the other seat?
Tighten the bolts and try moving the seats. The idea is to reposition the seat so that it does not rub (as much) against the other seat or the side of the seat well. It may take several attempts and you may have to fiddle with the other seat as well.