How do you align a belt pulley?
How to align the pulley?
- Remove the belt (see How to replace a belt).
- Loosen the driven pulley (shaft pulley), and adjust up and down to obtain level.
- Firmly re-tighten the pulley.
- Re-install and re-adjust the belt.
Where do you put the belt on an air compressor?
You might need to look at the owner’s manual or manufacturers website to determine the proper size belt for your compressor. Install the new belt on your compressor by placing it over the motor pulley and compressor pulley. The screws holding the motor should be loose, and the motor should be slid as close to the compressor as the slots will allow.
What’s the best way to replace an Air Conditioning belt?
Step 5: Install the new belt. Push or pull the tensioner to a position that allows the belt to be installed onto the pulleys. Once the belt is in place, you can release the tensioner and remove your tool. Step 1: Locate and loosen the compressor pivot. The compressor on older vehicles will generally have a pivot bracket.
Where is the AC belt located on a car?
Step 1: Locate the AC belt. The AC belt is routed over the AC compressor, which is located at the front of the engine compartment. You may need to raise the vehicle with a jack and support it with jack stands for access. Step 2: Determine which type of belt you have. Determine which type of belt you have.
Where is the tensioner on an air conditioner belt?
If you have a difficult time finding the tensioner, consult the belt routing diagram. This can typically be found on a decal placed somewhere in the engine compartment or in the vehicle repair manual. Step 2: Rotate the tensioner. Use a socket or wrench to slide the automatic tensioner away from the belt.
How do you change the belt on an air compressor?
Adjust the motor pulley so that the belt (4) runs parallel to the straightedge. Use a gear puller to move the pulley on the motor shaft. Tighten the setscrew after the pulley is positioned. Belt tension is determined by how much the belt moves when weight is applied.
Where is the belt on an air conditioner located?
Replacing the belt at the first sign of wear ensures it won’t break, leaving you without AC. Step 1: Locate the AC belt. The AC belt is routed over the AC compressor, which is located at the front of the engine compartment.
What should I do if my AC belt fails?
To do that, push down on the longest length of the belt – there should be about ½” of deflection. If not, loosen the belt and readjust as outlined in the previous step. That’s it! Now you don’t have to worry about losing your AC on a hot day due to a failed belt.
Where does the AC compressor go in a car?
Unless you drive a newfangled hybrid or electric car, the AC compressor in your vehicle is driven off a belt. The belt is strapped to the engine crankshaft balancer, which turns with the engine. Older vehicles use v-belts, which typically only drive the AC compressor.