How are the fog lights connected to the ground?
This terminal will carry power to the fog lights. The fog lights each have two wires, one for ground and one for the 12V power. One of these wires from each fog light has already been connected to ground. A three-way connection must be made joining the second wire from each of the fog lights to the red wire going to the relay terminal “87.”
How do you wire a fog light relay?
Connect a green wire from the “acc” terminal on the back of the switch to the number “86” terminal on the relay. The last terminal on the switch connects to the power source. This white wire will need a 10 amp inline fuse and is connected to the fuse block. The relay is wired next.
How to wire fog and driving lights harness?
Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp low beam lead. Turn off the ignition and the headlamps. Disconnect the battery. For Driving Lights: Turn on the high beam headlamps. Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp high beam lead.
What are the restrictions on installing fog lights?
Check your local laws. Some areas have restrictions on the type and color of lights you can install. Check your local regulations to make sure that your new lights are in compliance. Not all fog lights are approved for road use by the Department of Transportation.
Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp low beam lead. Turn off the ignition and the headlamps. Disconnect the battery. For Driving Lights: Turn on the high beam headlamps. Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp high beam lead.
Where does the Red Wire go on a fog light?
Make sure the relay is mounted close enough to the battery so the RED power lead will easily reach the positive (+) terminal of the battery. Connect the RED wire to the positive (+) battery terminal and to the relay terminal labeled 30. Route the RED / WHITE wires from the lamps to the relay.
How does a fog light hook up to a battery?
This hook up does away with the headlight lamp connection. Green wire connects directly to the battery to power switch / relay. Loosen the stud or bolts securing the fog or driving lamp to the bracket to adjust the lights up or down. Loosen the mounting bolts to the vehicle to adjust the lights left and right.
How do you find the low beam of a fog light?
Locate the low beam or high beam light lead on one headlamp by using a circuit tester. Use the following procedure: For Fog Lights: Turn on the low beam headlamps. Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp low beam lead.