What do the sub-codes on a Honda car mean?
Honda Service Sub-Codes Sub-Code What it Means 0 Perform multi-point inspection. 1 Tires need a rotation service. 2 Replace the cabin and engine air filters 3 Replace the transmission fluid.
What is the fault code for a Honda Accord?
P1297 Electric Load Detector (ELD) Circuit Low Voltage P1298 Electric Load Detector (ELD) Circuit High Voltage P1300 Random Misfire P1324 Knock Sensor Power Source Circuit Low Voltage P1336 Engine Speed (RPM) Fluctuation Sensor Intermittent Interruption P1337 Engine Speed (RPM) Fluctuation Sensor No Signal
What does Honda service code 100% oil life mean?
Customers don’t have to remember their maintenance schedule from memory as the Honda Maintenance Minder system shows the engine oil life in the information display as a percentage that begins at 100% oil life and you can monitor your oil over life percentage over time as you put miles on the vehicle.
What is the revision number on a Honda Accord S2000?
S2000 As further identification Honda ECUs have a software revision number inside the ECU. This is usually a two or three digit number stamped on the 28 pin ROM, or main processor. Accord and Prelude ECUs can use a letter and number code.
How is the problem code displayed on a Honda Foreman?
4. The problem code is displayed by a certain number of blinks “ – – “ on the gear indicator, which indicates the problem code by the number of blinks. If “N” (neutral) stays ON on the position indicator, the retrieval process was not correctly performed.
P1297 Electric Load Detector (ELD) Circuit Low Voltage P1298 Electric Load Detector (ELD) Circuit High Voltage P1300 Random Misfire P1324 Knock Sensor Power Source Circuit Low Voltage P1336 Engine Speed (RPM) Fluctuation Sensor Intermittent Interruption P1337 Engine Speed (RPM) Fluctuation Sensor No Signal
How to put esp on Honda 500 Rubicon?
1. Put the gear shift lever in neutral (be sure the neutral indicator comes on) and the ignition switch OFF (vehicle at a stop). 2. While pushing the UP and DOWN shift switches (ESP) simultaneously, turn the ignition key to the on position. 3.
4. The problem code is displayed by a certain number of blinks “ – – “ on the gear indicator, which indicates the problem code by the number of blinks. If “N” (neutral) stays ON on the position indicator, the retrieval process was not correctly performed.
How to change settings on Honda Foreman Rubicon?
If playback doesn’t begin shortly, try restarting your device. This channel is all about everything ATV’S. My life with the outdoors of Eastern Ontario. How to change the settings on Viper 3121V.
1. Put the gear shift lever in neutral (be sure the neutral indicator comes on) and the ignition switch OFF (vehicle at a stop). 2. While pushing the UP and DOWN shift switches (ESP) simultaneously, turn the ignition key to the on position. 3.