How to change the differential fluid in a S2000?
Pump new differential fluid into the differential until it starts to drip out the fill hole. Grab the fill bolt, pump a few more squirts into the differential, and quickly hand thread the fill bolt in. Torque the bolt to 33 lb-ft. Wipe up any excess lubricant, lower the car, and put your tools away.
What kind of washer do I need for a Honda S2000?
A differential drain plug crush washer (Honda Part No. 90401-PCZ-003). Here are some other things you will need: 2 qts. of your preferred gear lube oil (I used Mobil1 Synthetic Gear Lubricant LS 75W-90 after reading many forums; it only takes one qt., but I prefer to have another qt. on standby just in case).
What kind of lubricant do I need for my S2000?
2 qts. of your preferred gear lube oil (I used Mobil1 Synthetic Gear Lubricant LS 75W-90 after reading many forums; it only takes one qt., but I prefer to have another qt. on standby just in case). A good fluid pump that fits onto a 1 qt. container.
What kind of differential does a Toyota S2000 have?
By Rob Robinette The S2000 comes with a nice Torsen (geared TORque SENsing) limited slip differential (LSD). The problem with Torsen type differentials is if a driven wheel comes off the ground it acts like an open differential and spins the raised wheel while delivering no torque to the wheel on the ground.
A differential drain plug crush washer (Honda Part No. 90401-PCZ-003). Here are some other things you will need: 2 qts. of your preferred gear lube oil (I used Mobil1 Synthetic Gear Lubricant LS 75W-90 after reading many forums; it only takes one qt., but I prefer to have another qt. on standby just in case).
When was the last serviced Honda S2000 convertible?
Last serviced at 79,234 miles in Canandaigua, NY on 04/26/19 • Vehicle serviced • Maintenance inspection completed • Four tires balanced • Four tires mounted • Safety inspection performed • Emissions inspection performed. Mileage: 90,728 miles Body Type: Convertible Color: Blue Engine: 4 Cyl 2.2 L No accident or damage reported to CARFAX.
How do you replace a diff on a S2000?
Make sure your new diff has fluid in it before installation. To reinstall the diff lift it up into position using the floor jack. Keep the driveshafts and propeller shaft clear as you raise it. Move the diff to one side a couple of inches so you can compress one of the driveshaft joints and insert into the diff’s output shaft.