How long do clutches last Civic Si?
The clutch should be good beyond 100,000 miles.
How much should I charge for a clutch job?
The cost to repair a clutch can range between $500 to $2,500. It really depends on the car. Performance cars, exotic cars, and European cars are more expensive to replace the clutch than Japanese economy cars. Four wheel drive vehicles cost more than two wheel drive vehicles.
How long does it take to replace clutch on civic?
I can do this particular car in around 3-4 hours if I don’t get distracted. Realistically, you should give yourself 8-10 hours of actual work time plus whatever you spend fixing as you go. There are probably several different ways to approach this kind of work depending on the equipment available to you.
Do you need wheel chocks for Honda Civic?
Wheel chocks are not optional. If the car rolls and falls off of the jackstands onto you, you will die. Use a hydraulic jack rated for at least twice the full weight of the car. (1.5 tons X 2) – Cardboard to work on. Get several sheets.
How big of a hydraulic jack do I need for a civic?
Use a hydraulic jack rated for at least twice the full weight of the car. (1.5 tons X 2) – Cardboard to work on. Get several sheets. This job is messy and you want to preserve a clean environment.
What are the sockets on a Honda Civic?
– Sockets and extensions. Regular sockets: 12,14,17,19. Deep sockets: 10,12,14,17,19,21. 12-point sockets: 10,17. Short and long extensions. The 21mm deep socket is for the wheels, you can use the tire tool in the trunk. The 10mm and 17mm 12-point sockets are required to remove the pressure plate and flywheel bolts.
How does the clutch work on a Honda Civic?
Your Honda Civic uses a hydraulic clutch system to engage the transmission into the gears. When the clutch plate wears down, the system loses the required pressure needed to engage the gears, turning the car into a really heavy paperweight.
How do you replace the flywheel on a Honda Civic?
Use the following steps to replace the flywheel and clutch on your Honda Civic. The quickest way to reach the clutch is from underneath the chassis. In order to do this, use a jack to raise the vehicle and a pair of jack stands to support the chassis in the air. Also use this as an opportunity to drain the transmission fluid. Figure 1.
Where are the transmission bolts on a Honda Civic?
Remove the transmission top mount’s 17mm bolts. Proceed to remove the front transmission mount (three 17mm bolts and two 14mm bolts). Remove the final 19mm mount bolt located behind the transmission. Once done, loosen all four bolts that connect the transmission housing to the engine.
Where is the pressure plate on a Honda Civic?
Take the pressure plate and mount it on top of the clutch plate. Position the pressure plate so the three studs on the flywheel are visible. Once fitted, tighten the pressure plate bolts to 19 ft/lbs using a criss-cross pattern.