What are the torque specs on the front hub assembly?
The torque specifications for GM wheel hubs generally range between 107 to 225 foot-pounds, depending on the year and model.
How tight should the axle nut be?
The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn.
What is axle torque?
One of the most common mistakes people make when installing a new hub assembly is improperly torquing the axle nut. Proper torque secures the axle nut and keeps the proper load on the hub assembly. Second, the proper torque keeps the correct load on a hub assembly needed for longer bearing life.
What is the torque spec for CV axle?
Final torque (weight of vehicle on wheel) should be 265 Nm (195 Ft Lb) if using thread locking compound or initial torque + 1/4 turn if greased. Also, manual says nut or bolt should always be replaced.
Can you over tighten an axle nut?
An axle nut that is too tight will put too much preload on the hub bearings thus diminishing their life expectancy.
How tight should axle bolts be?
What is the wheel nut torque specifications?
New wheels should be re-torqued after the first 50 to 100 driving miles.
| Hardware Bolt or Stud Size | Typical Torque Range in Ft/Lbs | Minimum Number of Turns of Hardware Engagement |
|---|---|---|
| 12 x 1.5 mm | 70 – 80 | 6.5 |
| 12 x 1.25 mm | 70 – 80 | 8 |
| 14 x 1.5 mm | 85 – 90 | 7.5 |
| 14 x 1.25 mm | 85 – 90 | 9 |
How tight should front axle be?
Why are axle nuts so tight?
Propellers Up Front Just as you said you can pull the hub really hard once the axle nut is removed means that is a high stress point, so the axle nut being tight prevents that from happening under extreme driving conditions. Since it’s CV joints and not a solid axle, things can come apart outwards.
What should u-bolts be torqued to?
Helpful Expert Reply: If the U-bolts are 9/16 inch diameter, the torque specs should be between 65 to 95 foot lbs. If the U-bolts are 3/8 inch diameter, the torque should be between 30 and 50 foot lbs.
What is the torque on Chevy lug nuts?
The recommended lug nut torque for the Chevy Silverado is specified by the manufacturer as 140 ft. -lbs. This is recommended if using a torque wrench and will allow You to tighten the bolts without stripping or breaking the lug stud.