Do you need TPMS scan for Honda Odyssey?
Direct TPMS – OBD relearn, Auto relearn. Direct TPMS system requires a TPMS scan tool with the OBD module to connect to the vehicle’s DLC (VT56 or VT46 brands), step by step relearn procedures are written in the tool. The Honda Odyssey’s direct TPMS OBD relearn is unique compared to other OBD relearns.
How to put Odyssey in learning mode to reset TPMS?
Dismount your original tires from the wheels and swap the original TPMS sensors from the aluminum wheels into the steel wheels. Then mount the snows on the steel wheels. This way the TPMS unit will be looking for the sensors it already knows, so the dealer trip will not be required. However, a lot of extra work will go into switching the sensors.
What to do if your Honda Odyssey sliding door does not work?
With the control unit removed, spray the outside of the vehicle around the driver’s side rear window and the center rail cover. Check for leaks inside the compartment. If you see water entering, you must seal. Remove the two self tapping screws holding the center rail cover in place and remove the cover below the driver’s side rear window
Why is OBD 2 not communicating with scan tools?
You plug in the OBD II with the engine off and then turn on the engine – it should talk. Just plugging it in is not correct. Thanks for the post. You are correct. There is a system failure that prevent establishment of communication. The scan tools is plugged in and the key is on.
What causes Honda HDs to stop communicating with MICU?
Per the diagram on page 22-89 of the service manual the HDS/OBD-II attaches to the MICU computer built into the drivers kick panel fuse box. Fuses 6, 7, and 21 in that fuse box are used by the MICU – if any are blown it could cause the HDS to stop communicating. 2013 Honda CR-V Polished Metalic EX-L with Navi.
Why is my ECU not connecting for OBD2 scan?
The next time u go try to get your codes read make sure they turn your key all the way so it’s positioned right before you turn the car on, might sound lame but every time I go someplace to get my codes read the people will turn the key to the first notch and then look stupid as they turn around and say, I can’t figure out why it’s not connecting.
How to fix a car that won’t communicate with a scan tool?
This feature is not available right now. Please try again later. Scotty Kilmer, mechanic for the last 48 years, shows how to fix a broken car the won’t communicate with a scan tool so you can’t get any information on the problem. Sometimes it’s as easy as just disconnecting parts to find the problem. 1. Actron Scan Tool: http://amzn.to/2ngeCQJ 2.