What happens when you replace a ball joint on a Honda Civic?
If the rubber boot around the ball joint is busted, this is an indication that there is no grease left inside. You may also feel a wobble or vibration at the wheel. Replacing ball joints can take quite some time and requires specialty tools, so you may prefer going to a repair shop if you don’t have them.
Where do you put the ball joint press?
The tip of the ball joint press should be at the bottom of the boot. Use a 9 mm wrench to crank the pivot. Push the ball joint out. Use the hammer to hit the ball joint up and out. With the pliers, remove the snap ring from the rubber boot of the ball joint.
Where is the place Jack on a Honda Civic?
Place jack stands under the pinch welds. With the flat head screwdriver, undo the clip on the center of the spindle nut. With the 32 mm deep well socket, loosen the spindle nut by rotating it counterclockwise. This is easier if you position the wrench to push down instead of up.
How big is the spindle nut on a Honda Civic?
Spindle nut could be 36 mm depending on the your Accord’s model year. Once the spindle nut is off, unfasten the two bolts on the back of the caliper. Unfasten two additional bolts securing the brake line to the knuckle. Remove the caliper assembly, and use a bungee cord or zip ties to hang the caliper.
What are the ball joints on a Honda Civic?
This article applies to the Honda Civic (1992-2000). Ball joints are the smallest components that play a big role in making sure you arrive safely to your destination. Think of them as pivots that allow the suspension to flex as your wheel moves. You can tell if they need a replacement just by looking at them.
The tip of the ball joint press should be at the bottom of the boot. Use a 9 mm wrench to crank the pivot. Push the ball joint out. Use the hammer to hit the ball joint up and out. With the pliers, remove the snap ring from the rubber boot of the ball joint.
Place jack stands under the pinch welds. With the flat head screwdriver, undo the clip on the center of the spindle nut. With the 32 mm deep well socket, loosen the spindle nut by rotating it counterclockwise. This is easier if you position the wrench to push down instead of up.
Spindle nut could be 36 mm depending on the your Accord’s model year. Once the spindle nut is off, unfasten the two bolts on the back of the caliper. Unfasten two additional bolts securing the brake line to the knuckle. Remove the caliper assembly, and use a bungee cord or zip ties to hang the caliper.