How does a high pressure AC system work?
To measure the pressure in the high-pressure side of your system, you need a little fancier piece of equipment. The pressures in the high-pressure side of your system are so high that it requires special hoses and connections along with a special gauge to contain the pressure and ensure you don’t release any of the refrigerant to the atmosphere.
Where are the low and high AC pressure switches located?
The low-pressure side switch is found before the AC compressor, while the high-pressure switch comes after the compressor. Most AC pressure switches are found within the engine compartment, but some manufacturers put them elsewhere. A look in your service manual will show you the appropriate location for your model. AC Pressure Switch Function
What should the pressure be on the low side of the AC?
The pressure reading from the low side should be between 25 and 30 psi and the high side between 200 and 250 psi. But if you see the AC low side high, high side low, such as the low side is 100 and the high side is 150, there might be problems with any of the inner components.
Where is the refrigerant pressure sensor located in a car?
The location of the refrigerant pressure sensor can differ a lot between car models and depending on whether you are going to replace the high or low-pressure sensor. But usually, the sensors are most often located in the engine bay or under the front/on the AC condenser on the front of the car.
What’s the air pressure in a Honda Civic?
Ambient temp Humidity % Inlet air temp Static system pressure 45 psi minimum Center vent temp ~30°F < ambient Low side pressure Typical: ~ 30 psi High side pres- sure Typical: 2.2 to 2.5 X ambient °F Pressure behavior when AC is shut off: High Side Pressure PSI Low Side Pressure PSI Center Vent Air Temperature °F Inlet Air Temperature °F 1.
What do you need to know about Honda Civic a / C?
2006-2011 Honda Civic A/C Diagnosis and Repair EXPANSION VALVE (Meters the required amount of refrigerant into the evaporator) RECEIVER/DRYER DESICCANT (Traps debris, and removes moisture) A/C COMPRESSOR (Suction and compression) A/C CONDENSER (Radiation of heat) A/C PRESSURE SENSOR
When to use the a / C pressure sensor triple function?
A/C PRESSURE SENSOR (Triple function) When the refrigerant is below 196 kPa (2.0 kgf/cm2, 28 psi) or above 3,140 kPa (32 kgf/cm2, 455 psi), the A/C pressure switch opens the circuit to the A/C switch and stops the air conditioning to protect the A/C compressor.
What happens when you stop the Honda Civic a / C compressor?
Discharge pressure abnormally high After stopping A/C compressor, pres- sure drops about 196 kPa (2.0 kgf/cm2, 28 psi) quickly, and then falls gradually. Air in system Recover, evacuate, and recharge with specifi ed amount. No bubbles in sight glass when A/C condenser is cooled by water.