What is the engine code on a 2003 Honda CRV?
2003 Honda CRV with a check engine light on and a bad hesitation at around 2700 RPM. It almost acts like a governer. The codes are: P1259 Manufacturer control fuel air metering.
What was the 2003 CRV VTEC failure error?
P1259 Vtec failure… 2003 CRV. P1259 Vtec failure error. Power cuts out around 3K RPM’s. Test and replaced VTEC Solenoid Valve and Pressure Switch. Remove, cleaned screens which were partially clogged, and tested VTC Oil Control Valve.
What was the 2003 CRV p1259 failure error?
2003 CRV. P1259 Vtec failure error. Power cuts out around 3K RPM’s. Test and replaced VTEC Solenoid Valve and Pressure Switch. Remove, cleaned screens which were partially clogged, and tested VTC Oil Control Valve. Appears to function fine.
Why does my car not maintain 3000 rpm?
When trying to run the Idle learn procedure, the vehicle will not maintain 3000 RPM. After about a minute @3000 RPM it will drop to 2500 RPM, then cycle between 2500 and 2800 RPM at about 1/2 second intervals. Is this consistent with a faulty VTC Oil Control Valve?
Can a Honda CRV p1259 VTEC malfunction?
Typically, there aren’t many symptoms associated with P1259. You’ll get the check engine light, that’s usually about it. If the VTEC system isn’t working at all you may notice a dip in power. The VTEC system controls the valve timing in your Honda.
When is the code detected on Honda CRV?
When is the code detected? The VTEC system activates the VTEC solenoid valve by command from the powertrain control module (PCM), and it charges/discharges the hydraulic circuit of the VTEC mechanism that is installed in the valve system to switch valve timing between Low and High.
2003 Honda CRV with a check engine light on and a bad hesitation at around 2700 RPM. It almost acts like a governer. The codes are: P1259 Manufacturer control fuel air metering.
Typically, there aren’t many symptoms associated with P1259. You’ll get the check engine light, that’s usually about it. If the VTEC system isn’t working at all you may notice a dip in power. The VTEC system controls the valve timing in your Honda.
When is the code detected? The VTEC system activates the VTEC solenoid valve by command from the powertrain control module (PCM), and it charges/discharges the hydraulic circuit of the VTEC mechanism that is installed in the valve system to switch valve timing between Low and High.
P1259 Vtec failure… 2003 CRV. P1259 Vtec failure error. Power cuts out around 3K RPM’s. Test and replaced VTEC Solenoid Valve and Pressure Switch. Remove, cleaned screens which were partially clogged, and tested VTC Oil Control Valve.