Where is SRS unit located?
In most cars it is under the center console that is between the two front seats, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat.
How to remove the SRS airbag control module?
Steps to remove airbag control module 1 First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor. 2 Disconnect the positive battery cable and wait 3 min. 3 You are now safe to unplug the airbag control module harness wiring plugs.
Where is the SRS computer module in a car?
Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed. First find the srs computer module. In most cars it is under the center console that is between the two front seats, or center of the dash on the floor.
How long does it take for SRS to deploy?
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed. First find the srs computer module. In most cars it is under the center console that is between the two front seats, or center of the dash on the floor.
Can You unplug the SRS airbag control module?
You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.